OCB100-KIT Datasheet, PDF (20/24 Pages) OPTEK Technologies – Auto-Calibration Design Kit

indicator), or no fluid (no indicators will be lit). If the sensor is unable
to calibrate, a red LED will flash multiple times and then remain lit.
This is an indication that there is an insufficient infrared light reaching
the phototransistor, such as when a dark object or dark fluid is in the
optical path, or when the OCB100 circuit just needs higher gain.
The onboard jumper can be configured to set the gain at three differ-
ent levels. See the OCB350 Series data sheet www.optekinc.com for
more details.
COMPLETE PART NUMBERS OF OPB350 AND OPB350 SERIES
OPB350
20 OPB350L062
PCB mount for 1/8” tubing
PCB mount for 1/16” tubing
OPB350W062Z Wired assembly for 1/16” tubing, with mounting tabs
OPB350L125
PCB mount for 1/8” tubing
OPB350C125Z
Wired assembly for 1/8” tubing, mounting tabs & Molex con-
nector 50-57-9404
OPB350W125Z Wired assembly for 1/8” tubing, with mounting tabs
OPB350L187
PCB mount for 3/16” tubing
OPB350W187Z Wired assembly for 3/16” tubing, with mounting tabs
OPB350L250
PCB mount for 1/4” tubing
OPB350W250Z Wired assembly for 1/4” tubing, with mounting tabs
OCB350L062Z OPB350L062Z mounted on OCB100AZ calibration circuit board
OCB350L125Z OPB350L125Z mounted on OCB100AZ calibration circuit board
OCB350L187Z OPB350L187Z mounted on OCB100AZ calibration circuit board
OCB350L250Z OPB350L250Z mounted on OCB100AZ calibration circuit board
OCB100-KIT