English
Language : 

OPL535 Datasheet, PDF (1/2 Pages) OPTEK Technologies – Photologic Sensors
Product Bulletin OPL535
December 1997
Photologic® Sensors
Types OPL535, OPL535-OC, OPL536, OPL536-OC
Features
• Four output options
• High noise immunity
• Direct TTL/LSTTL CMOS interface
• Low cost plastic side-looking package
• Mechanically and spectrally matched
to the OP145 and OP245 series LED's
• Data rates to 250 kBaud
• Low power consumption
Description
The OPL535, OPL535-OC, OPL536,
OPL536-OC contain a monolithic
integrated circuit which incorporates a
photodiode, amplifier, voltage regulator,
Schmitt trigger and an NPN output
transistor on a single silicon chip.
The OPL535 and OPL536 include a 10
KΩ pull-up resistor (RL) from output to
VCC. The OPL535-OC and OPL536-OC
have an open-collector output.
These devices exhibit very stable
performance over supply voltages
ranging from 4.5 V to 16 V and a wide
range of irradiance levels.
The Photologic® chip is encapsulated in
a molded plastic package which has a
recessed integral lens for enhanced
optical coupling combined with
mechanical protection.
Absolute Maximum Ratings (TA = 25o C unless otherwise noted)
Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V
Storage Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40o C to +100o C
Operating Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40o C to +85o C
Lead Soldering Temperature Range [1/16 inch (1.6 mm) from case for 5 sec. with
soldering iron] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 240o C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 mW
Voltage at Output Lead(4) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 V
Sinking Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA
Notes:
(1) Derate linearly 2.67 mW/o C above 70o C.
(2) RMA flux is recommended. Duration can be extended to 10 sec. maximum when flow
soldering. Max 20 grams force may be applied to the leads when soldering.
(3) Irradiance measurements are made with λi = 935 nm.
(4) OC versions only. For ICC on pull-up versions add VCC/10 kΩ .
Schematics
OPL535 Buffer/Pull-up Resistor
VCC
OUT
GND
Light On - Output High
OPL535-OC Buffer/OC
VCC
OUT
OPL536 Inverter/Pull-up Resistor
VCC
OUT
GND
Light On - Output Low
OPL536-OC Inverter/OC
VCC
OUT
Optek Technology, Inc.
1215 W. Crosby Road
GND
Light On - Output High
GND
Light On - Output Low
Carrollton, Texas 75006 (972) 323-2200
Fax (972) 323-2396
4-6