OPF560 Datasheet, PDF (1/4 Pages) OPTEK Technologies – 125 MHz Fiber Optic Receiver

Product Bulletin OPF560
February 1996
125 MHz Fiber Optic Receiver
Types OPF560, OPF561, OPF562
OPF560
VCC
VEE
OUTPUT
OPF561
OUTPUT
VEE
Features
• Low Cost
• Data Rates up to 155 MBd
• Wide Temperature Range
• SMA, ST*, or plastic cap style
• Wave Solderable
Description
The OPF560 series receiver is a low cost
solution for high speed fiber optic
communication designs.
The output of the receiver is an analog,
low impedance, emitter follower voltage
source capable of driving an amplifier or
level translating circuitry. This allows the
subsequent circuitry to use the device in
either the analog mode or translated to
ECL/TTL levels for use in a digital mode
at data rates up to 155MBaud.
The receiver is comprised of a high
speed, low noise, photodiode coupled to
a transimpedance amplifier which
produces an output voltage proportional
to the input light amplitude. This hybrid
approach solves many of the problems of
high speed data link designs by placing a
pre-amplifier close to the photodiode.
The amplification of the transimpedance
amplifier makes the output signal much
less susceptible to EMI.
An AC coupled receiver application
circuit is shown. Both the 10 ohm
resistor and by-pass capacitor are
critical.
*ST is a registered trademark of AT&T.
VCC
OPF562
OUTPUT
VEE
VCC
Absolute Maximum Ratings (T_A = 25^o C unless otherwise noted)
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -55^o C to +85^o C
Operating Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40^o C to +85^o C
Lead Soldering Temperature (for 10 sec.) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260^o C
Signal Pin Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to V_CC
Supply Voltage (V_CC - V_EE) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 6.0 V
Output Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 mA
This component is susceptible to damage from electrostatic discharge (ESD). Normal
static precautions should be taken in handling and assembly of this component to
prevent ESD damage or degradation.
Optek Technology, Inc. 1215 W. Crosby Road Carrollton, Texas 75006 [phone]
Fax [phone]
8-108