TPP3XGDS0C000E2G Datasheet, PDF (1/6 Pages) OPLINK Communications Inc. – 850nm SFP+ Transceiver

TPP3XGDS0x000E2G
850nm SFP+ Transceiver
Features
 850nm VCSEL laser
 Transmission distance up to 300m on OM3 MM fiber
 Low power consumption
 Wide Case Operating Temperature Range
 Compliant with SFP+ Electrical MSA SFF-8431
 Compliant with SFP+ Mechanical MSA SFF-8432
 Digital Diagnostics Monitoring (DDM) through Serial
Interface comply with SFF-8472, Rev. 10.4
 RoHS 6/6 compliant
 Compliant with product safety standards
Description
The TPP3XGDS0x000E2G is an enhanced small form
factor pluggable (SFP+) fiber optic transceiver with digital
diagnostics monitoring functionality (DDM). Supporting
Ethernet and Fiber Channel standards makes it ideally
suited for 10Gbps data-com and storage area network
applications. DDM functionality (alarm and warning
features) is integrated into the design via an I²C serial
interface per the Multi-Source Agreement (MSA) SFF-8472,
Rev. 10.4.
The transceiver supports data rates ranging from
11.3Gbps down to 8Gbps. It provides an excellent solution
for transmission at 850nm over up to 300m 2000MHzkm
multimode fiber. The sub-watt power consumption and
excellent EMI performance allow system design with high
port density. The product is RoHS compliant and is
designed and tested in accordance with industry safety
standards. The transceiver is Class I Laser product per
U.S. FDA/CDRH and international IEC-60825 standards.
The TPP3XGDS0x000E2G transceiver connects to
standard 20-pad SFP+ connectors for hot plug capability.
This allows the system designer to make configuration
changes or maintenance by simply plugging in different
transceivers without removing the power supply from the
host system. The transmitter and receiver DATA interfaces
are internally AC-coupled. LV-TTL Transmitter Disable
control input and Loss of Signal (LOS) output interfaces
are also provided.
The transceiver has bail-type latch, which offers an easy
and convenient way to release the modules. The latch is
compliant with the SFP MSA.
The transceiver operates from a single +3.3V power supply
over an operating case temperature range of -5°C to
+70°C (Commercial), or -5°C to +85°C (Extended). The
housing is made of metal for EMI immunity.
Absolute Maximum Ratings
Parameters
Symbol
Min
Storage Temperature Range
TST
- 40
Operating
Commercial
-5
Temperature
TOP
Range ¹
Extended
-5
Operating Relative Humidity ²
RH
0
Supply Voltage Range
VCC
- 0.5
1 _{Measured on top side of SFP+ module at the front center vent hole of the cage}
2 _{Non condensing}
Max
+ 85
+ 70
+ 85
85
+ 3.6
Units
°C
°C
%
V
46335 Landing Pkwy‧Fremont CA 94538-6407‧Tel: [phone]‧Fax: [phone]‧Email: [e-mail]‧Web: www.oplink.com
Page 1 of 6
S0365. Rev.01. 2012-11-27