MC10EP58_06 Datasheet, PDF (6/11 Pages) ON Semiconductor – 3.3V / 5V ECL 2:1 Multiplexer

MC10EP58, MC100EP58
Table 10. 100EP DC CHARACTERISTICS, NECL V_CC = 0 V, V_EE = −5.5 V to −3.0 V (Note 12)
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
I_EE
Power Supply Current
20
28
37
20
31
39
25
33
42 mA
V_OH
Output HIGH Voltage (Note 13)
−1145 −1020 −895 −1145 −1020 −895 −1145 −1020 −895 mV
V_OL
Output LOW Voltage (Note 13)
−1945 −1820 −1695 −1945 −1820 −1695 −1945 −1820 −1695 mV
V_IH
Input HIGH Voltage (Single−Ended) −1225
−880 −1225
−880 −1225
−880 mV
V_IL
Input LOW Voltage (Single−Ended)
−1945
−1625 −1945
−1625 −1945
−1625 mV
I_IH
Input HIGH Current
150
150
150 mA
I_IL
Input LOW Current
0.5
0.5
0.5
mA
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
12. Input and output parameters vary 1:1 with V_CC.
13. All loading with 50 W to V_CC − 2.0 V.
Table 11. AC CHARACTERISTICS V_CC = 0 V; V_EE = −3.0 V to −5.5 V or V_CC = 3.0 V to 5.5 V; V_EE = 0 V (Note 14)
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
f_max
t_PLH,
t_PHL
Maximum Frequency
(See Figure 2. F_max/JITTER)
>3
>3
>3
GHz
Propagation Delay to
Output Differential
ps
D to Q,Q 200 280 380 210 310 410 220 340 420
SEL to Q,Q
t_JITTER
V_PP
Cycle−to−Cycle Jitter
(See Figure 2. F_max/JITTER)
Input Voltage Swing
(Differential Configuration)
0.2 < 2
0.2 < 2
0.2 < 2 ps
150 800 1200 150 800 1200 150 800 1200 mV
t_r
Output Rise/Fall Times
t_f
(20% − 80%)
Q, Q 70 120 170 80 130 180 100 150 200 ps
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
14. Measured using a 750 mV source, 50% duty cycle clock source. All loading with 50 W to V_CC − 2.0 V.
http://onsemi.com
6