CAX803 Datasheet, PDF (6/9 Pages) ON Semiconductor – 3-Pin Microprocessor Power Supply Supervisors

CAX803, CAX809, CAX810
Detailed Descriptions
Reset Timing
The reset signal is asserted LOW for the CAX803/CAX809 and HIGH for the CAX810 when the power supply voltage falls
below the threshold trip voltage and remains asserted for at least 140 ms after the power supply voltage has risen above the
threshold.
5V
V_CC
V_TH
0V
T_D
5V
RESET/OUT
0V
T_R
Reset Timeout Period
(140 ms
minimum)
CAX803, CAX809
5V
RESET
0V
CAX810
Figure 6. Reset Timing Diagram
V_CC Transient Response
The CAX803/CAX809/CAX810 protect mPs against
brownout failure. Short duration transients of 4 msec or less
and 100 mV amplitude typically do not cause a false RESET.
Figure 7 shows the maximum pulse duration of negative−
going V_CC transients that do not cause a reset condition.
As the amplitude of the transient goes further below the
threshold (increasing V_TH − V_CC), the maximum pulse
duration decreases. In this test, the V_CC starts from an initial
voltage of 0.5 V above the threshold and drops below it by
the amplitude of the overdrive voltage (V_TH − V_CC).
30
T_AMB = 25°C
25
20
15
CAX809Z
10
CAX809M
5
0
1
10
100
1000
RESET OVERDRIVE V_TH − V_CC (mV)
Figure 7. Maximum Transient Duration without
Causing a Reset Pulse vs. Reset Comparator
Overdrive
http://onsemi.com
6