MC74LV594A Datasheet, PDF (5/12 Pages) ON Semiconductor – 8-Bit Shift Register

MC74LV594A
MAXIMUM RATINGS
Symbol
Parameter
Value
Unit
V_CC
DC Supply Voltage
V_I
DC Input Voltage
V_O
DC Output Voltage Active Mode (Note 1)
High Impedance or Power−Off Mode
−0.5 to +7.0
V
−0.5 to V_CC + 0.5
V
−0.5 to V_CC + 0.5
V
−0.5 to +7.0
I_IK
I_OK
I_IN
I_O
I_CC
I_GND
T_STG
T_L
T_J
q_JA
DC Input Clamp Current
DC Output Clamp Current
DC Input Current
DC Output Source / Sink Current
DC Supply Current per Supply Pin
DC Ground Current per Ground Pin
Storage Temperature Range
Lead temperature, 1 mm from Case for 10 Seconds
Junction temperature under Bias
Thermal Resistance SOIC
TSSOP
±20
mA
±35
mA
±20
mA
±35
mA
±75
mA
±75
mA
−65 to +150
°C
260
°C
+150
°C
112
°C
148
P_D
Power Dissipation in Still Air at SOIC
TSSOP
500
mW
450
MSL
Moisture Sensitivity
Level 1
F_R
V_ESD
Flammability Rating Oxygen Index: 30% − 35%
ESD Withstand Voltage Human Body Model (Note 2)
Machine Model (Note 3)
Charged Device Model (Note 4)
UL−94−VO (0.125 in)
> 3000
V
>400
N/A
I_Latchup
Latchup Performance Above V_CC and Below GND at 85°C (Note 5)
±300
mA
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. I_O absolute maximum rating must be observed.
2. Tested to EIA/JESD22−A114−A.
3. Tested to EIA/JESD22−A115−A.
4. Tested to JESD22−C101−A.
5. Tested to EIA/JESD78.
RECOMMENDED OPERATING CONDITIONS (Note 6)
Symbol
Parameter
Min
Max
Unit
V_CC
DC Supply Voltage (Referenced to GND)
2.0
6.0
V
V_I
DC Input Voltage (Referenced to GND)
0
V_CC
V
V_O
DC Output Voltage (Referenced to GND)
0
V_CC
V
T_A
Operating Free−Air Temperature
−55
+125
°C
t_r, t_f
Input Rise or Fall Rate
V_CC = 2.0 V
V_CC = 4.5 V
V_CC = 6.0 V
0
1000
nS
0
500
0
400
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond
the Recommended Operating Ranges limits may affect device reliability.
6. All unused inputs of the device must be held at V_CC or GND to ensure proper device operation.
www.onsemi.com
5