LM358ADR2G Datasheet, PDF (5/14 Pages) ON Semiconductor – Single Supply Dual Operational Amplifiers

LM258, LM358, LM358A, LM2904, LM2904A, LM2904V, NCV2904, NCV2904V
ELECTRICAL CHARACTERISTICS (V_CC = 5.0 V, V_EE = Gnd, T_A = 25°C, unless otherwise noted.)
LM2904
LM2904A
LM2904V, NCV2904
NCV2904V
Characteristic
Symbol Min Typ Max Min Typ Max Min Typ Max Unit
Input Offset Voltage
V_CC = 5.0 V to 30 V, V_IC = 0 V to V_CC −1.7 V,
V_O ] 1.4 V, R_S = 0 W
T_A = 25°C
T_A = T_high (Note 8)
T_A = T_low (Note 8)
V_IO
mV
− 2.0 7.0 − 2.0 7.0 −
−
− 10 −
−
10 −
−
− 10 −
−
10 −
− 7.0
− 13
− 10
Average Temperature Coefficient of Input Offset
Voltage
T_A = T_high to T_low (Note 8)
DV_IO/DT − 7.0 −
− 7.0 −
− 7.0 − mV/°C
Input Offset Current
T_A = T_high to T_low (Note 8)
Input Bias Current
T_A = T_high to T_low (Note 8)
I_IO
− 5.0 50 − 5.0 50 − 5.0 50 nA
− 45 200 − 45 200 − 45 200
I_IB
− −45 −250 − −45 −100 − −45 −250
− −50 −500 − −50 −250 − −50 −500
Average Temperature Coefficient of Input Offset
Current
T_A = T_high to T_low (Note 8)
DI_IO/DT − 10
−
− 10
−
− 10
− pA/°C
Input Common Mode Voltage Range (Note 9),
V_CC = 30 V
V_CC = 30 V, T_A = T_high to T_low
V_ICR
0
− 28.3 0
− 28.3 0
− 28.3 V
0
− 28 0
−
28 0
−
28
Differential Input Voltage Range
V_IDR
−
− V_CC −
− V_CC −
− V_CC
V
Large Signal Open Loop Voltage Gain
R_L = 2.0 kW, V_CC = 15 V, For Large V_O Swing,
T_A = T_high to T_low (Note 8)
A_VOL
V/mV
25 100 − 25 100 − 25 100 −
15 −
− 15 −
− 15 −
−
Channel Separation
1.0 kHz ≤ f ≤ 20 kHz, Input Referenced
CS
− −120 −
− −120 −
− −120 −
dB
Common Mode Rejection
R_S ≤ 10 kW
Power Supply Rejection
CMR
50 70
−
50 70
−
50 70
−
dB
PSR 50 100 − 50 100 − 50 100 −
dB
Output Voltage−High Limit
T_A = T_high to T_low (Note 8)
V_CC = 5.0 V, R_L = 2.0 kW, T_A = 25°C
V_CC = 30 V, R_L = 2.0 kW
V_CC = 30 V, R_L = 10 kW
V_OH
V
3.3 3.5 − 3.3 3.5 − 3.3 3.5 −
26 −
− 26 −
− 26 −
−
27 28 − 27 28 − 27 28 −
Output Voltage−Low Limit
V_CC = 5.0 V, R_L = 10 kW,
T_A = T_high to T_low (Note 8)
V_OL
− 5.0 20 − 5.0 20 − 5.0 20 mV
Output Source Current
V_ID = +1.0 V, V_CC = 15 V
I_O +
20 40
− 20 40
− 20 40
−
mA
Output Sink Current
V_ID = −1.0 V, V_CC = 15 V
V_ID = −1.0 V, V_O = 200 mV
I_{O −}
10 20 − 10 20 − 10 20 − mA
−
−
−−
−
−
−−
−
mA
Output Short Circuit to Ground (Note 10)
I_SC
− 40 60 − 40 60 − 40 60 mA
Power Supply Current (Total Device)
T_A = T_high to T_low (Note 8)
V_CC = 30 V, V_O = 0 V, R_L = ∞
V_CC = 5 V, V_O = 0 V, R_L = ∞
I_CC
mA
− 1.5 3.0 − 1.5 3.0 − 1.5 3.0
− 0.7 1.2 − 0.7 1.2 − 0.7 1.2
8. LM258: T_low = −25°C, T_high = +85°C
LM358, LM358A: T_low = 0°C, T_high = +70°C
LM2904/LM2904A: T_low = −40°C, T_high = +105°C
LM2904V & NCV2904: T_low = −40°C, T_high = +125°C
NCV2904 and NCV2904V are qualified for automotive use. NCV2904V: T_low = −40°C, T_high = +150°C
9. The input common mode voltage or either input signal voltage should not be allowed to go negative by more than 0.3 V. The upper end of
the common mode voltage range is V_CC − 1.7 V.
10. Short circuits from the output to V_CC can cause excessive heating and eventual destruction. Destructive dissipation can result from
simultaneous shorts on all amplifiers.
http://onsemi.com
5