CM1690 Datasheet, PDF (5/10 Pages) California Micro Devices Corp – Praetorian L-C LCD and Camera EMI Filter Array with ESD Protection in Ultra-Thin uDFN Packages

CM1690
ELECTRICAL OPERATING CHARACTERISTICS ^{(SEE NOTE1)}
SYMBOL
L
C_TOTAL
C
V_DIODE
I_LEAK
V_SIG
V_ESD
R_DYN
PARAMETER
Channel Inductance
CONDITIONS
MIN TYP MAX UNITS
12
nH
Total Channel Capacitance
At 2.5VDC Reverse
25 33
40
pF
Bias, 1MHz, 30mVAC
Capacitance C1
At 2.5VDC Reverse
16.5
pF
Bias, 1MHz, 30mVAC
Standoff Voltage
I_DIODE = 10µA
Diode Leakage Current (reverse bias)
V_DIODE = +3.3V
Signal Clamp Voltage
Positive Clamp
Negative Clamp
I_LOAD = 10mA
I_LOAD = –10mA;
Note 3
In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883, Method
3015
b) Contact Discharge per IEC 61000-4-2 Level 4
Notes 2 and 4
6.0
V
0.1 0.3
µA
5.6 6.8 9.0
V
–1.5 –0.8 –0.4
V
±30
kV
±15
kV
Dynamic Resistance
Positive
Negative
2.3
Ω
0.9
Ω
f_C
R_INSULATION
R_CHANNEL
Roll-off Frequency at -6dB Attenuation
Z = _SOURCE 50Ω, Z_LOAD = 50Ω
Insulation Resistance
Channel Resistance
V_DIODE=3.3V, Note 4
330
10
8
MHz
ΜΩ
Ω
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin (i.e. if ESD is applied to pin A1 then
clamping voltage is measured at pin C1).
Note 4: Unused pins are left open.
Rev. 2 | Page 5 of 10 | www.onsemi.com