MC74HC4094A Datasheet, PDF (4/12 Pages) ON Semiconductor – 8-Bit Shift and Store Register

MC74HC4094A
MAXIMUM RATINGS
Symbol
Parameter
Value
Unit
V_CC DC Supply Voltage (Referenced to GND)
– 0.5 to + 7.0
V
V_in DC Input Voltage (Referenced to GND)
– 0.5 to V_CC + 0.5 V
V_out DC Output Voltage (Referenced to GND)
– 0.5 to V_CC + 0.5 V
I_in
DC Input Current, per Pin
± 20
mA
I_out DC Output Current, per Pin
± 35
mA
I_CC DC Supply Current, V_CC and GND Pins
± 75
mA
P_D Power Dissipation in Still Air,
SOIC Package†
500
mW
TSSOP Package†
450
T_stg Storage Temperature
– 65 to + 150
°C
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of
these limits are exceeded, device functionality should not be assumed, damage may occur and
reliability may be affected.
†Derating − SOIC Package: – 7 mW/°C from 65° to 125°C
TSSOP Package: − 6.1 mW/°C from 65° to 125°C
RECOMMENDED OPERATING CONDITIONS
Symbol
Parameter
Min
V_CC DC Supply Voltage (Referenced to GND)
2.0
V_in, V_out DC Input Voltage, Output Voltage
0
(Referenced to GND)
T_A Operating Temperature, All Package Types
–55
t_r, t_f Input Rise and Fall Time
(Figure 1)
V_CC = 2.0 V
0
V_CC = 4.5 V
0
V_CC = 6.0 V
0
Max
6.0
V_CC
Unit
V
V
+125 °C
1000 ns
500
400
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high−impedance cir-
cuit. For proper operation, V_in and
V_out should be constrained to the
range GND v (V_in or V_out) v V_CC.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or V_CC).
Unused outputs must be left open.
www.onsemi.com
4