CM1461 Datasheet, PDF (4/18 Pages) ON Semiconductor – Praetorian C-L-C LCD and Camera EMI FilterArray with ESD Protection

CM1461
STANDARD OPERATING CONDITIONS
PARAMETER
Operating Temperature Range
RATING
–40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS ^{(SEE NOTE1)}
SYMBOL PARAMETER
L
Channel Inductance
C_TOTAL Total Channel Capacitance
C
Capacitance C1
V_DIODE
I_LEAK
V_SIG
Standoff Voltage
Diode Leakage Current (reverse bias)
Signal Clamp Voltage
Positive Clamp
Negative Clamp
V_ESD In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883, Method
3015
b) Contact Discharge per IEC 61000-4-2 Level 4
R_DYN
Dynamic Resistance
Positive
Negative
f
Roll-off Frequency at -6dB Attenuation
R
Z_SOURCE=50Ω, Z_LOAD=50Ω
CONDITIONS
MIN TYP MAX UNITS
20
nH
At 2.5VDC Reverse
16 20
24
pF
Bias, 1MHz, 30mVAC
At 2.5VDC Reverse
10
pF
Bias, 1MHz, 30mVAC
I_DIODE=10µA
V_DIODE=+3.3V
6.0
V
0.1 1.0
µA
I_LOAD = 10mA
I_LOAD = –10mA
Notes 2 and 3
5.6 6.8
9
V
–1.5 –0.8 -0.4
V
±30
kV
±15
kV
2.3
Ω
0.9
Ω
400
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin (i.e. if ESD is applied to pin A1 then
clamping voltage is measured at pin C1). Unused pins are left open.
Rev. 2 | Page 4 of 18 | www.onsemi.com