English
Language : 

NS5S1153 Datasheet, PDF (3/9 Pages) ON Semiconductor – DPDT USB 2.0 High Speed / Audio Switch with Negative Swing Capability
NS5S1153
OPERATING CONDITIONS
MAXIMUM RATINGS
Symbol
Pins
Parameter
Value
Unit
VCC
VBUS
VIS
VCC
VBUS_CTRL
D+ to COM+
D− to COM−
Positive DC Supply Voltage
VBUS Control Input Voltage
Analog Signal Voltage
−0.5 to +6.0
V
−0.5 to +6.0
V
−0.5 to +6.0
V
R to COM+
L to COM−
−2.5 to VCC + 0.5
VIS
VIN
ICC
TS
IIS_CON
COM+, COM−
ASel
VCC
COM+, COM−
R, L, D+, D−
DC Signal Voltage Tolerance (<24 hours)
Control Input Override Voltage
Positive DC Supply Current
Storage Temperature
Analog Signal Continuous Current−Closed Switch
5.25
V
−0.5 to +6.0
V
50
mA
−65 to +150
°C
$100
mA
IIS_PK
COM+, COM−
R, L, D+, D−
Analog Signal Continuous Current 10% Duty Cycle
$500
mA
IIN
ASel
Control Input Override Current
1
mA
VBUS_CTRL
VBUS Control Input Current
1
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
RECOMMENDED OPERATING CONDITIONS
Symbol
Pins
Parameter
Min
Max
Unit
VCC
VBUS
VIS
VCC
VBUS_CTRL
D+ to COM+
D− to COM−
Positive DC Supply Voltage
VBUS Control Input Voltage
Analog Signal Voltage (Note 1)
2.7
GND
GND
5.0
V
5.25
V
VCC
V
R to COM+
L to COM−
−2.0
VCC
VIN
ASel
Control Input Override Voltage
GND
VCC
V
TA
Operating Temperature
−40
+85
°C
Minimum and maximum values are guaranteed through test or design across the Recommended Operating Conditions, where applic-
able. Typical values are listed for guidance only and are based on the particular conditions listed for section, where applicable. These
conditions are valid for all values found in the characteristics tables unless otherwise specified in the test conditions.
1. In USB mode, any signal applied to the off−state audio inputs R, L may not swing below ground or above 1.5 V.
http://onsemi.com
3