MC74VHC4316_11 Datasheet, PDF (3/12 Pages) ON Semiconductor – Digital Power Supplies

MC74VHC4316
MAXIMUM RATINGS
Symbol
Parameter
Value
Unit
V_CC Positive DC Supply Voltage
(Ref. to GND) – 0.5 to + 7.0
V
(Ref. to V_EE) – 0.5 to + 14.0
V_EE Negative DC Supply Voltage (Ref. to GND)
– 7.0 to + 0.5
V
V_IS Analog Input Voltage
V_EE – 0.5
V
to V_CC + 0.5
V_in DC Input Voltage (Ref. to GND)
– 0.5 to V_CC + 0.5 V
I
DC Current Into or Out of Any Pin
± 25
mA
P_D Power Dissipation in Still Air
SOIC Package*
500
mW
TSSOP Package*
450
T_stg Storage Temperature
– 65 to + 150
°C
T_L Lead Temperature, 1 mm from Case for 10 Seconds
°C
(SOIC or TSSOP Package)
260
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress
ratings only. Functional operation above the Recommended Operating Conditions is not implied.
Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
*Derating − SOIC Package: – 7 mW/°C from 65° to 125°C
TSSOP Package: − 6.1 mW/°C from 65° to 125°C
For high frequency or heavy load considerations, see Chapter 2 of the ON Semiconductor
High−Speed CMOS Data Book (DL129/D).
RECOMMENDED OPERATING CONDITIONS
Symbol
Parameter
Min
Max Unit
V_CC Positive DC Supply Voltage (Ref. to GND)
2.0
6.0
V
V_EE Negative DC Supply Voltage (Ref. to GND)
– 6.0 GND
V
V_IS Analog Input Voltage
V_EE
V_CC
V
V_in Digital Input Voltage (Ref. to GND)
GND
V_CC
V
V_IO* Static or Dynamic Voltage Across Switch
−
1.2
V
T_A Operating Temperature, All Package Types
– 55 + 125 °C
t_r, t_f Input Rise and Fall Time
(Control or Enable Inputs)
(Figure 10)
V_CC = 2.0 V
0
V_CC = 3.0 V
0
V_CC = 4.5 V
0
V_CC = 6.0 V
0
1000 ns
600
500
400
*For voltage drops across the switch greater than 1.2 V (switch on), excessive V_CC current may
be drawn; i.e., the current out of the switch may contain both V_CC and switch input components.
The reliability of the device will be unaffected unless the Maximum Ratings are exceeded.
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high−impedance cir-
cuit. For proper operation, V_in and
V_out should be constrained to the
range GND v (V_in or V_out) v V_CC.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or V_CC).
Unused outputs must be left open.
I/O pins must be connected to a
properly terminated line or bus.
http://onsemi.com
3