MC74HCT4851A Datasheet, PDF (3/13 Pages) ON Semiconductor – Analog Multiplexers/ Demultiplexers with Injection Current Effect Control with LSTTL Compatible Inputs

MC74HCT4851A
MAXIMUM RATINGS
Symbol
Parameter
Value
Unit
V_CC Positive DC Supply Voltage (Referenced to GND) –0.5 to + 7.0
V
V_in DC Input Voltage (Any Pin) (Referenced to GND) –0.5 to V_CC + 0.5 V
I
DC Current, Into or Out of Any Pin
$25
mA
P_D Power Dissipation in Still Air,
Plastic DIP†
750
mW
SOIC Package†
500
TSSOP Package†
450
T_stg Storage Temperature Range
–65 to + 150
°C
T_L Lead Temperature, 1 mm from Case for 10 Seconds
°C
Plastic DIP, SOIC or TSSOP Package
260
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress
ratings only. Functional operation above the Recommended Operating Conditions is not implied.
Extended exposure to stresses above the Recommended Operating Conditions may affect device
reliability.
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high−impedance cir-
cuit. For proper operation, V_in and
V_out should be constrained to the
range GND v (V_in or V_out) v V_CC.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or V_CC).
Unused outputs must be left open.
RECOMMENDED OPERATING CONDITIONS
Symbol
Parameter
Min
Max Unit
V_CC Positive DC Supply Voltage (Referenced to GND) 2.0
6.0
V
V_in DC Input Voltage (Any Pin) (Referenced to GND) GND
V_CC
V
V_IO* Static or Dynamic Voltage Across Switch
0.0
1.2
V
T_A Operating Temperature Range, All Package Types
– 55 + 125 °C
t_r, t_f Input Rise/Fall Time
V_CC = 2.0 V
0
(Channel Select or Enable Inputs) V_CC = 4.5 V
0
V_CC = 6.0 V
0
1000 ns
500
400
*For voltage drops across switch greater than 1.2 V (switch on), excessive V_CC current may be
drawn; i.e., the current out of the switch may contain both V_CC and switch input components. The
reliability of the device will be unaffected unless the Maximum Ratings are exceeded.
DC CHARACTERISTICS — Digital Section (Voltages Referenced to GND) V_EE = GND, Except Where Noted
Symbol
Parameter
Condition
Guaranteed Limit
V_CC
V −55 to 25°C ≤85°C ≤125°C Unit
V_IH Minimum High−Level Input Voltage,
Channel−Select or Enable Inputs
R_on = Per Spec
4.5
2.0
to
5.5
2.0
2.0
V
V_IL Maximum Low−Level Input Voltage,
Channel−Select or Enable Inputs
R_on = Per Spec
4.5
0.8
to
5.5
0.8
0.8
V
I_in
Maximum Input Leakage Current on Digital Pins V_in = V_CC or GND
(Enable/A/B/C)
5.5
± 0.1
± 1.0 ± 1.0 mA
I_CC Maximum Quiescent Supply Current
(per Package)
V_in(digital) = V_CC or GND 5.5
2.0
V_in(analog) = GND
20
40
mA
http://onsemi.com
3