English
Language : 

MC10E151_16 Datasheet, PDF (3/7 Pages) ON Semiconductor – 5V ECL 6‐Bit D Register
◁
MC10E151, MC100E151
Table 3. MAXIMUM RATINGS
Symbol
Parameter
Condition 1
Condition 2
Rating
Unit
VCC PECL Mode Power Supply
VEE
NECL Mode Power Supply
VI
PECL Mode Input Voltage
NECL Mode Input Voltage
Iout
Output Current
VEE = 0 V
VCC = 0 V
VEE = 0 V
VCC = 0 V
Continuous
Surge
VI ≤ VCC
VI ≥ VEE
8
V
−8
V
6
V
−6
50
mA
100
TA
Operating Temperature Range
Tstg
Storage Temperature Range
qJA
Thermal Resistance (Junction-to-Ambient) 0 lfpm
500 lfpm
PLCC−28
0 to +85
−65 to +150
63.5
43.5
°C
°C
°C/W
qJC
Thermal Resistance (Junction-to-Case)
VEE
PECL Operating Range
NECL Operating Range
Standard Board
PLCC−28
22 to 26
4.2 to 5.7
−5.7 to −4.2
°C/W
V
Tsol
Wave Solder (Pb-Free)
265
°C
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
Table 4. 10E SERIES PECL DC CHARACTERISTICS (VCC = 5.0 V, VEE = 0.0 V (Note 1))
0°C
25°C
85°C
Symbol
IEE
VOH
VOL
VIH
VIL
IIH
IIL
Characteristic
Power Supply Current
Output HIGH Voltage (Note 2)
Output LOW Voltage (Note 2)
Input HIGH Voltage
Input LOW Voltage
Input HIGH Current
Input LOW Current
Min
3980
3050
3830
3050
0.5
Typ
4070
3210
3995
3285
0.3
Max
4160
3370
4160
3520
Min
4020
3050
3870
3050
0.5
Typ
4105
3210
4030
3285
0.25
Max
4190
3370
4190
3520
Min
4090
3050
3940
3050
0.3
Typ
4185
3227
4110
3302
0.2
Max Unit
mA
4280 mV
3405 mV
4280 mV
3555 mV
mA
mA
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
1. Input and output parameters vary 1:1 with VCC. VEE can vary −0.46 V / +0.06 V.
2. Outputs are terminated through a 50 W resistor to VCC − 2.0 V.
www.onsemi.com
3
 ▷