MC100LVEL92_16 Datasheet, PDF (3/5 Pages) ON Semiconductor – 5V Triple PECL Input to LVPECL Output Translator

MC100LVEL92
Table 3. PECL INPUT DC CHARACTERISTICS (V_CC = 5.0 V; LV_CC = 3.3 V; GND = 0 V Note 1))
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
IV_CC
V_IH
V_IL
PECL V_BB
V_IHCMR
I_IH
I_IL
PECL Power Supply Current
Input HIGH Voltage (Single-Ended)
Input LOW Voltage (Single-Ended)
Output Voltage Reference
Input HIGH Voltage Common Mode
Range (DIfferential) (Note 2)
V_pp < 500 mV
V_pp ≥ 500 mV
Input HIGH Current
Input LOW Current
D
D
3835
3190
3.62
1.3
1.5
0.5
−600
12
4120
3515
3.74
3835
3190
3.62
4.8 1.2
4.8 1.4
150
0.5
−600
12
4120
3525
3.74
3835
3190
3.62
4.8 1.2
4.8 1.4
150
0.5
−600
12 mA
4120 mV
3525 mV
3.74 V
V
4.8
4.8
150 mA
mA
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
1. Input parameters vary 1:1 with V_CC. V_CC can vary 4.5 V to 5.5 V.
2. V_IHCMR min varies 1:1 with GND. V_IHCMR max varies 1:1 with V_CC. The V_IHCMR range is referenced to the most positive side of the differential
input signal. Normal operation is obtained if the HIGH level falls within the specified range and the peak-to-peak voltage lies between V_PPmin
and 1.0 V.
Table 4. LVPECL OUTPUT DC CHARACTERISTICS (V_CC = 5.0 V; LV_CC = 3.3 V; GND = 0 V (Note 1))
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
ILV_CC
V_OH
V_OL
LVPECL Power Supply Current
Output HIGH Voltage (Note 2)
Output LOW Voltage (Note 2)
20
20
21 mA
2215 2295 2420 2275 2345 2420 2275 2345 2420 mV
1470 1605 1745 1490 1595 1680 1490 1595 1680 mV
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
1. Output parameters vary 1:1 with LV_CC. V_CC can vary 3.0 V to 3.8 V.
2. Outputs are terminated through a 50 W resistor to LV_CC − 2.0 V.
www.onsemi.com
3