NBXSBA024_11 Datasheet, PDF (2/6 Pages) ON Semiconductor – 2.5 V / 3.3 V, 622.08 MHz LVPECL Clock Oscillator LVPECL Differential Output

NBXSBA024, NBXSBB024, NBXMBB024
OE 1
NC 2
6 V_DD
5 CLK
NC 1
OE 2
6 V_DD
5 CLK
GND 3
4 CLK
GND 3
4 CLK
NBXSxxxxx
NBXMxxxxx
Figure 2. Pin Connections (Top View)
Table 1. PIN DESCRIPTION
Pin No.
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ₁
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ₂
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ³
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ⁴
Symbol
OE/NC*
NC/OE*
GND
CLK
I/O
LVTTL/LVCMOS
Control Input
N/A
Power Supply
LVPECL Output
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ₅
CLK
LVPECL Output
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ₆
V_DD
Power Supply
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ _{*NBXMBA024 device pinout}
Description
Output Enable Pin. When left floating pin defaults to logic HIGH and output is active.
See OE pin description Table 2.
No Connect.
Ground 0 V
Non−Inverted Clock Output. Typically loaded with 50 W receiver termination resistor to
V_TT = V_DD − 2 V.
Inverted Clock Output. Typically loaded with 50 W receiver termination resistor to
V_TT = V_DD − 2 V.
Positive power supply voltage. Voltage should not exceed 2.5 V ±5% or 3.3 V ±10%.
Table 2. OUTPUT ENABLE TRI−STATE FUNCTION
OE Pin
Output Pins
Open
Active
HIGH Level
Active
LOW Level
High Z
Table 3. ATTRIBUTES
Characteristic
Value
Internal Default State Resistor
170 kW
ESD Protection
Human Body Model
Machine Model
2 kV
200 V
Meets or Exceeds JEDEC Standard EIA/JESD78 IC Latchup Test
1. For additional Moisture Sensitivity information, refer to Application Note AND8003/D.
Table 4. MAXIMUM RATINGS
Symbol
Parameter
Condition 1
Condition 2
Rating
Units
V_DD Positive Power Supply
I_out
LVPECL Output Current
GND = 0 V
Continuous
Surge
4.6
V
25
mA
50
T_A
Operating Temperature Range
−40 to +85
°C
T_stg
Storage Temperature Range
−55 to +120
°C
T_sol
Wave Solder
See Figure 5
260
°C
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
http://onsemi.com
2