MC74VHCT86A_14 Datasheet, PDF (2/6 Pages) ON Semiconductor – Quad 2-Input XOR Gate / CMOS Logic Level Shifter

MC74VHCT86A
MAXIMUM RATINGS
Symbol
Parameter
Value
Unit
V_CC DC Supply Voltage
V_in DC Input Voltage
V_out DC Output Voltage
– 0.5 to + 7.0
V
– 0.5 to + 7.0
V
V_CC = 0 – 0.5 to + 7.0
V
High or Low State – 0.5 to V_CC + 0.5
I_IK Input Diode Current
− 20
mA
I_OK Output Diode Current (V_OUT < GND; V_OUT > V_CC)
± 20
mA
I_out DC Output Current, per Pin
± 25
mA
I_CC DC Supply Current, V_CC and GND Pins
± 50
mA
P_D Power Dissipation in Still Air,
SOIC Package†
500
mW
TSSOP Package†
450
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high−impedance cir-
cuit. For proper operation, V_in and
V_out should be constrained to the
range GND v (V_in or V_out) v V_CC.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or V_CC).
Unused outputs must be left open.
T_stg Storage Temperature
– 65 to + 150
_C
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of
these limits are exceeded, device functionality should not be assumed, damage may occur and
reliability may be affected.
†Derating — SOIC Package: – 7 mW/_C from 65_ to 125_C
TSSOP Package: − 6.1 mW/_C from 65_ to 125_C
RECOMMENDED OPERATING CONDITIONS
Characteristics
Symbol
Min
Max
Unit
DC Supply Voltage
V_CC
2.0
5.5
V
DC Input Voltage
V_IN
0.0
5.5
V
DC Output Voltage
V_CC = 0
High or Low State
V_OUT
0.0
5.5
V
0.0
V_CC
Operating Temperature Range
T_A
−55
+85
°C
Input Rise and Fall Time
V_CC = 3.3V ± 0.3V
V_CC = 5.0V ± 0.5V
t_r , t_f
0
100
ns/V
0
20
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond
the Recommended Operating Ranges limits may affect device reliability.
NOISE CHARACTERISTICS (Input t_r = t_f = 3.0ns, C_L = 50pF, V_CC = 5.0V, Measured in SOIC Package)
T_A = 25°C
Symbol
Characteristic
Typ
Max
Unit
V_OLP Quiet Output Maximum Dynamic V_OL
0.3
0.8
V
V_OLV Quiet Output Minimum Dynamic V_OL
− 0.3
− 0.8
V
V_IHD
Minimum High Level Dynamic Input Voltage
3.5
V
V_ILD
Maximum Low Level Dynamic Input Voltage
1.5
V
http://onsemi.com
2