LB11660FV Datasheet, PDF (2/10 Pages) Sanyo Semicon Device – Single-Phase Full-Wave Fan Motor Driver

LB11660FV
Specifications
Absolute Maximum Ratings at Ta = 25C
Parameter
Symbol
Conditions
Ratings
Unit
VCC maximum supply voltage
VM maximum supply voltage
OUT pin maximum output
current
OUT pin output voltage 1
OUT pin output voltage 2
PRE pin maximum source
current
PRE pin maximum sink current
VCC max
VM max
IOUT max
Rf  0.39
VOUT max 1
VOUT max 2
IPSO max
T  0.4s
IPSI max
20
V
20
V
1.5
A
20
V
26.5
V
30
mA
7
mA
PRE pin output voltage
VP max
20
V
HB maximum output current
VTH input pin voltage
HB max
VTH max
10
mA
7
V
FG output pin voltage
FG output current
Allowable power dissipation
Operating temperature
Storage temperature
VFG max
IFG max
Pd max
Topr
Tstg
When mounted on a circuit board *1
*2
18
V
10
mA
0.8
W
30 to +90
C
55 to +150
C
*1 Specified circuit board : 114.3  76.1  1.6mm³, glass epoxy.
*2: Tj max is 150°C. This device must be used under conditions such that the chip temperature does not exceed Tj = 150°C during operation.
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed,
damage may occur and reliability may be affected.
Recommended Operating Conditions at Ta = 25C
Parameter
VCC supply voltage
VM supply voltage
Current limiter operation range
VTH input level voltage range
Symbol
VCC
VM
ILIM
VTH
Conditions
Hall sensor input common-mode
input voltage range
VICM
Ratings
Unit
4 to 15
V
3 to 15
V
0.6 to 1.2
V
0 to 6
V
0.2 to 3
V
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended
Operating Ranges limits may affect device reliability.
www.onsemi.com
2