|
CAV25320 Datasheet, PDF (2/13 Pages) ON Semiconductor – 32-Kb SPI Serial CMOS EEPROM | |||
|
◁ |
CAV25320
Table 1. ABSOLUTE MAXIMUM RATINGS
Parameters
Ratings
Units
Operating Temperature
â45 to +130
°C
Storage Temperature
â65 to +150
°C
Voltage on any Pin with Respect to Ground (Note 1)
â0.5 to +6.5
V
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
1. The DC input voltage on any pin should not be lower than â0.5 V or higher than VCC + 0.5 V. During transitions, the voltage on any pin may
undershoot to no less than â1.5 V or overshoot to no more than VCC + 1.5 V, for periods of less than 20 ns.
Table 2. RELIABILITY CHARACTERISTICS (Note 2)
Symbol
Parameter
Min
Units
NEND (Note 3) Endurance
1,000,000
Program / Erase Cycles
TDR
Data Retention
100
Years
2. These parameters are tested initially and after a design or process change that affects the parameter according to appropriate AECâQ100
and JEDEC test methods.
3. Page Mode, VCC = 5 V, 25°C.
Table 3. D.C. OPERATING CHARACTERISTICS (VCC = 2.5 V to 5.5 V, TA = â40°C to +125°C, unless otherwise specified.)
Symbol
Parameter
Test Conditions
Min
Max
Units
ICCR
ICCW
ISB1
Supply Current (Read Mode)
Supply Current (Write Mode)
Standby Current
ISB2
Standby Current
IL
Input Leakage Current
ILO
Output Leakage Current
Read, VCC = 5.5 V, 10 MHz, SO open
Write, VCC = 5.5 V, CS = VCC
VIN = GND or VCC, CS = VCC,
WP = VCC, VCC = 5.5 V
VIN = GND or VCC, CS = VCC,
WP = GND, VCC = 5.5 V
VIN = GND or VCC
CS = VCC,
VOUT = GND or VCC
2
mA
3
mA
4
mA
6
mA
â2
2
mA
â1
2
mA
VIL
VIH
VOL1
VOH1
Input Low Voltage
Input High Voltage
Output Low Voltage
Output High Voltage
IOL = 3.0 mA
IOH = â1.6 mA
â0.5
0.3 VCC
V
0.7 VCC
VCC + 0.5
V
0.4
V
VCC â 0.8 V
V
Table 4. PIN CAPACITANCE (Note 2) (TA = 25°C, f = 1.0 MHz, VCC = +5.0 V)
Symbol
Test
Conditions
COUT
CIN
Output Capacitance (SO)
Input Capacitance (CS, SCK, SI, WP, HOLD)
VOUT = 0 V
VIN = 0 V
Min
Typ
Max
Units
8
pF
8
pF
http://onsemi.com
2
|
▷ |