CAV24C32 Datasheet, PDF (2/10 Pages) ON Semiconductor – CMOS Serial EEPROM

(TSSOP−8)
CAV24C32
DEVICE MARKINGS
(SOIC−8)
C32F
AYMXXX
G
C32F
A
Y
M
XXX
G
= Specific Device Code
= Assembly Location
= Production Year (Last Digit)
= Production Month (1-9, O, N, D)
= Last Three Digits of Assembly Lot Number
= Pb−Free Package
24C32F
AYMXXX
G
24C32F = Specific Device Code
A
= Assembly Location
Y
= Production Year (Last Digit)
M
= Production Month (1-9, O, N, D)
XXX = Last Three Digits of Assembly Lot Number
G
= Pb−Free Package
Table 1. ABSOLUTE MAXIMUM RATINGS
Parameters
Ratings
Units
Storage Temperature
–65 to +150
°C
Voltage on any Pin with Respect to Ground (Note 1)
–0.5 to +6.5
V
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
1. During input transitions, voltage undershoot on any pin should not exceed −1 V for more than 20 ns. Voltage overshoot on pins A₀, A₁, A₂
and WP should not exceed V_CC + 1 V for more than 20 ns, while voltage on the I²C bus pins, SCL and SDA, should not exceed the absolute
maximum ratings, irrespective of V_CC.
Table 2. RELIABILITY CHARACTERISTICS (Note 2)
Symbol
Parameter
Min
Units
N_END (Note 3) Endurance
1,000,000
Program/Erase Cycles
T_DR
Data Retention
100
Years
2. These parameters are tested initially and after a design or process change that affects the parameter according to appropriate AEC−Q100
and JEDEC test methods.
3. Page Mode, V_CC = 5 V, 25°C.
Table 3. D.C. OPERATING CHARACTERISTICS (V_CC = 2.5 V to 5.5 V, T_A = −40°C to +125°C, unless otherwise specified.)
Symbol
Parameter
Test Conditions
Min
Max
Units
I_CCR
Read Current
Read, f_SCL = 400 kHz
1
mA
I_CCW
I_SB
I_L
V_IL
V_IH
Write Current
Standby Current
I/O Pin Leakage
Input Low Voltage
Input High Voltage
V_OL
Output Low Voltage
Write, f_SCL = 400 kHz
2
mA
All I/O Pins at GND or V_CC T_A = −40°C to +125°C
5
mA
Pin at GND or V_CC
2
mA
−0.5
0.3 x V_CC
V
A₀, A₁, A₂ and WP
0.7 x V_CC
V_CC + 0.5
V
SCL and SDA
0.7 x V_CC
5.5
V_CC > 2.5 V, I_OL = 3 mA
0.4
V
http://onsemi.com
2