NCP1235 Datasheet, PDF (18/34 Pages) ON Semiconductor – Fixed Frequency Current Mode Controller

V_HV
V_HV(start)
V_HV(stop)
NCP1235
Brown-out
DRV
Starts at next
V_CC(ON)
time
t _HV
Figure 32. AC Input Brown−out Timing Diagram
time
Oscillator with Maximum Duty Cycle and Frequency
Jittering
The NCP1235 includes an oscillator that sets the
switching frequency of 65 kHz with an accuracy of $7%.
The maximum duty cycle of the DRV pin is 80%, with an
accuracy of $7%.
In order to improve the EMI signature, the switching
frequency jitters $10% around its nominal value, with a
triangle−wave shape and at a frequency of 125 Hz. This
frequency jittering is active even when the frequency is
decreased to improve the EMI in light load condition.
Clamped Driver
The supply voltage for the NCP1235 can be as high as
28 V, but most of the MOSFETs that will be connected to the
DRV pin cannot accept more than 20 V on their gate. The
driver pin is therefore clamped safely below 16 V. This
driver has a typical current capability of $500 mA.
VCC
Clamp
f_OSC
f_OSC + 6
Nominal f_OSC
f_OSC − 6
DRV signal
DRV
Figure 34. Clamped Driver
8%
(125 Hz)
Figure 33. Frequency Jittering
Time
www.onsemi.com
18