ENA2260 Datasheet, PDF (13/23 Pages) ON Semiconductor – 8M-bit (1024K x 8) Serial Flash Memory

LE25S80FD
4. Write Enable
Before performing any of the operations listed below, the device must be placed in the write enable state. Operation is
the same as for setting status register WEN to "1", and the state is enabled by inputting the write enable command.
"Figure 8 Write Enable" shows the timing waveforms when the write enable operation is performed. The write enable
command consists only of the first bus cycle, and it is initiated by inputting (06h).
 Small sector erase, sector erase, chip erase
 Page program
 Status register write
5. Write Disable
The write disable command sets status register WEN to "0" to prohibit unintentional writing. "Figure 9 Write Disable"
shows the timing waveforms. The write disable command consists only of the first bus cycle, and it is initiated by
inputting (04h). The write disable state (WEN "0") is exited by setting WEN to "1" using the write enable command
(06h).
Figure 8 Write Enable
Figure 9 Write Disable
CS
SCK
SI
SO
Mode3
Mode0
01234567
8CLK
06h
MSB
High Impedance
CS
SCK
SI
SO
Mode3
Mode0
01234567
8CLK
04h
MSB
High Impedance
6. Power-down
The power-down command sets all the commands, with the exception of the silicon ID read command and the
command to exit from power-down, to the acceptance prohibited state (power-down). "Figure 10 Power-down" shows
the timing waveforms. The power-down command consists only of the first bus cycle, and it is initiated by inputting
(B9h). However, a power-down command issued during an internal write operation will be ignored. The power-down
state is exited using the power-down exit command (power-down is exited also when one bus cycle or more of the
silicon ID read command (ABh) has been input). "Figure 11 Exiting from Power-down" shows the timing waveforms of
the power-down exit command.
Figure 10 Power-down
Power down
mode
Figure 11 Exiting from Power-down
Power down
mode
CS
SCK
SI
SO
Mode3
Mode0
tDP
01234567
8CLK
B9h
MSB
High Impedance
CS
SCK
SI
SO
Mode3
Mode0
01234567
tPRB
8CLK
ABh
MSB
High Impedance
No.A2260-13/23