PCS3P2537A Datasheet, PDF (1/7 Pages) PulseCore Semiconductor – Low Power Peak EMI Reduction IC

PCS3P2537A
Peak EMI Reduction IC
Features
• 1x Peak EMI Reduction IC
• Input Frequency: 18MHz-36MHz
• Output Frequency: 18MHz-36MHz
• Frequency Deviation @ 27MHz: -0.25%
• Modulation Rate @ 27MHz: 30.1KHz
• Supply Voltage: 3.3V ± 0.3V
• Operating current less than 8mA @ 27MHz
• Spread Spectrum Enable Control
• CMOS design
• 8L-WDFN (8L-TDFN) package
Product Description
PCS3P2537A is a 1x spread spectrum frequency
modulator designed to reduce electromagnetic
interference (EMI) at the clock source, allowing system
wide reduction of EMI of down stream clock and data
dependent signals. The device allows significant system
cost savings by reducing the number of circuit board
layers, ferrite beads and shielding and other passive
components that are traditionally required to pass EMI
regulations.
PCS3P2537A modulates the output of a single PLL in
order to “spread” the bandwidth of a synthesized clock,
and more importantly, decreases the peak amplitudes of
its harmonics. This result in significantly lower system
EMI compared to the typical narrow band signal produced
by oscillators and most frequency generators. Lowering
EMI by increasing a signal’s bandwidth is called ‘spread
spectrum clock generation.’
PCS3P2537A has a frequency range of 18MHz-36MHz,
and accepts input clock either from a Crystal or from an
external reference and locks on to it delivering a 1x
spread spectrum clock output. It has an SSON control for
enabling and disabling Spread Spectrum function.
PCS3P2537A operates with a supply voltage of 3.3V, and
is available in 8 L-WDFN package.
Application
PCS3P2537A is targeted towards PC peripheral devices
and embedded systems.
Block Diagram
VDD
SSON
CLKIN / XIN
XOUT
Crystal
Oscillator
PLL
ModOUT
GND
©2010 SCILLC. All rights reserved.
JANUARY 2010 – Rev. 1
Publication Order Number:
PCS3P2537/D