NCV7425 Datasheet, PDF (1/20 Pages) ON Semiconductor – LIN Transceiver with Voltage Regulator and Reset Pin

NCV7425
LIN Transceiver with
Voltage Regulator and
Reset Pin
General Description
The NCV7425 is a fully featured local interconnect network (LIN)
transceiver designed to interface between a LIN protocol controller
and the physical bus.
The NCV7425 LIN device is a member of the in−vehicle
networking (IVN) transceiver family of ON Semiconductor that
integrates a LIN v2.1 physical transceiver and a low−drop voltage
regulator. It is designed to work in harsh automotive environment and
is submitted to the TS16949 qualification flow.
The LIN bus is designed to communicate low rate data from control
devices such as door locks, mirrors, car seats, and sunroofs at the
lowest possible cost. The bus is designed to eliminate as much wiring
as possible and is implemented using a single wire in each node. Each
node has a slave MCU−state machine that recognizes and translates
the instructions specific to that function. The main attraction of the
LIN bus is that all the functions are not time critical and usually relate
to passenger comfort.
http://onsemi.com
MARKING
DIAGRAM
16
16
1
SOIC−16 LEAD
WIDE BODY
EXPOSED PAD
CASE 751AG
NCV7425−x
AWLYYWWG
1
x = 0 or 5
A = Assembly Location
WL = Wafer Lot
YY = Year
WW = Work Week
G = Pb−Free Package
Features
• LIN−Bus Transceiver
♦ LIN compliant to specification revision 2.1
(backward compatible to versions 2.0 and 1.3) and
J2602
♦ Bus Voltage ±45 V
♦ Transmission Rate up to 20 kBaud
♦ Integrated Slope Control for Improved EMI
Compatibility
• Package
♦ SOIC−16 Wide Body Green Package with Exposed
Pad
• Protection
♦ Thermal Shutdown
♦ Indefinite Short−Circuit Protection on Pins LIN and
WAKE Towards Supply and Ground
♦ Load Dump Protection (45 V)
♦ Bus Pins Protected Against Transients in an
Automotive Environment
♦ ESD Protection Level for LIN, INH, WAKE and
V_BB up to ±10 kV
• Voltage Regulator
♦ Two Device Versions: Output Voltage 3.3 V or 5 V
For Loads up to 150 mA
ORDERING INFORMATION
See detailed ordering and shipping information in the
package dimensions section on page 19 of this data sheet.
♦ Under−Voltage Detector with a Reset Output to the
Supplied Microcontroller
♦ INH Output for Auxiliary Purposes (switching of an
external pull−up or resistive divider towards battery,
control of an external voltage regulator etc.)
• Modes
♦ Normal Mode: LIN Communication in Either Low
(up to 10 kBaud) or Normal Slope
♦ Sleep Mode: V_CC is Switched “off” and No
Communication on LIN Bus
♦ Stand−by Mode: V_CC is Switched “on” but There is
No Communication on LIN Bus
♦ Wake−up Bringing the Component From Sleep
Mode Into Standby Mode is Possible Either by LIN
Command or Digital Input Signal on WAKE Pin
Wake−up from LIN Bus can also be Detected and
Flagged When the Chip is Already in Standby Mode
• These are Pb−Free Devices
Typical Applications
• Automotive
• Industrial Networks
© Semiconductor Components Industries, LLC, 2012
1
May, 2012 − Rev. 1
Publication Order Number:
NCV7425/D