NCV7342_16 Datasheet, PDF (1/15 Pages) ON Semiconductor – High Speed Low Power CAN Transceiver

NCV7342
High Speed Low Power CAN
Transceiver
Description
The NCV7342 CAN transceiver is the interface between a
controller area network (CAN) protocol controller and the physical
bus and may be used in both 12 V and 24 V systems. The transceiver
provides differential transmit capability to the bus and differential
receive capability to the CAN controller.
The NCV7342 is an addition to the CAN high−speed transceiver
family complementing NCV734x CAN stand−alone transceivers and
previous generations such as AMIS42665, AMIS3066x, etc.
Due to the wide common−mode voltage range of the receiver inputs
and other design features, the NCV7342 is able to reach outstanding
levels of electromagnetic susceptibility (EMS). Similarly, extremely
low electromagnetic emission (EME) is achieved by the excellent
matching of the output signals.
Features
• Compatible with the ISO 11898−2, ISO 11898−5 Standards
• High Speed (up to 1 Mbps)
• V_IO Pin on NCV7342−3 Version Allowing Direct Interfacing with
3 V to 5 V Microcontrollers
• V_SPLIT Pin on NCV7342−0 Version for Bus Common Mode
Stabilization
• Very Low Current Consumption in Standby Mode with Wake−up via
the Bus
• Excellent Electromagnetic Susceptibility (EMS) Level Over Full
Frequency Range. Very Low Electromagnetic Emissions (EME) Low
EME Also Without Common Mode (CM) Choke
• Bus Pins Protected Against >15 kV System ESD Pulses
• Transmit Data (TxD) Dominant Time−out Function
• Bus Dominant Time−out function in Standby Mode
• Under All Supply Condition the Chip Behaves Predictably
• No Disturbance of the Bus Lines with an Unpowered Node
• Thermal Protection
• Bus Pins Protected Against Transients in an Automotive
Environment
• Bus Pins Short Circuit Proof to Supply Voltage and Ground
• These are Pb−Free Devices
Quality
• Wettable Flank Package for Enhanced Optical Inspection
• NCV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
Typical Applications
• Automotive
• Industrial Networks
www.onsemi.com
8
1
SOIC−8
D SUFFIX
CASE 751AZ
1
DFN8
MW SUFFIX
CASE 506CS
MARKING DIAGRAMS
8
NV7342−x
ALYW G
G
1
1
NV7342−x
ALYWG
G
NV7342−x= Specific Device Code
x = 0 or 3
A
= Assembly Location
L
= Wafer Lot
Y
= Year
W
= Work Week
G
= Pb−Free Package
(Note: Microdot may be in either location)
PIN ASSIGNMENTS
1
TxD
2
GND
3
V_{CC 4}
RxD
8
STB
7
CANH
6
CANL
5
V_SPLIT (−0)
V_IO (−3)
TxD 1
GND 2
V_CC 3
RxD 4
EP Flag
8 STB
7 CANH
6 CANL
5 V_IO
(Top Views)
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 13 of this data sheet.
© Semiconductor Components Industries, LLC, 2016
1
February, 2016 − Rev. 3
Publication Order Number:
NCV7342/D