|
NCP5425SOEVB Datasheet, PDF (1/22 Pages) ON Semiconductor – Dual Synchronous Buck Controller | |||
|
NCP5425
Dual Synchronous
Buck Controller
The NCP5425 is a highly flexible dual buck controller with internal
gate drivers that can be used with two input power supplies and one or
two outputs in multiple configurations. The part contains all the
circuitry required for two independent synchronous dual NFET buck
regulators utilizing a feed forward voltage mode control method. The
NCP5425 can run from a single supply ranging from 4.6 to 12 V and
support a single two phase or dual single phase outputs. When used as
a dual output controller, the second output tracks voltage transients
from the first. Power blanking for low noise applications is supported
as well as independent cycleâbyâcycle current limiting. The part is
available in a 20 pin TSSOP package allowing the designer to
minimize PCB area.
Features
⢠Operation Over 4.6 to 13.2 V
⢠Dual Synchronous Buck Design
⢠Configurable as a Single Two Phase Output or Two Single Phase
Outputs
⢠Programmable Power Sharing and Budgeting from Two Independent
Supplies
⢠0.8 V "1% Reference for Low Voltage Outputs
⢠1.5 A Peak Power Drive
⢠Switch Blanking for Noise Sensitive Applications through use of
ROSC Pin
⢠Programmable Frequency, 150 kHz to 750 kHz Operation
⢠Programmable SoftâStart
⢠CycleâbyâCycle Overcurrent Protection
⢠Independent Programmable Current Limits
⢠100% Duty Cycle for Fast Transient Response
⢠Internal Slope Compensation
⢠OutâofâPhase Synchronization between the Controllers
⢠Input Undervoltage Lockout
⢠On/Off Enable through use of the COMP Pins
⢠Power Supply Sequencing
⢠These are PbâFree Devices
Applications
⢠DDR Memory Power
⢠Graphics Cards
http://onsemi.com
20
1
TSSOPâ20
DB SUFFIX
CASE 948E
PIN CONNECTIONS AND
MARKING DIAGRAM
1
GATEH1
GATEL1
GND
BST
NC
NC
IS+1
ISâ1
VFB1
COMP1
NCP
5425
ALYW G
G
20
GATEH2
GATEL2
VCC
ROSC
MODE
ISâ2
IS+2
VREF2
VFB2
COMP2
A = Assembly Location
L = Wafer Lot
Y = Year
W = Work Week
G = PbâFree Package
(Note: Microdot may be in either location)
ORDERING INFORMATION
Device
Package
Shippingâ
NCP5425DB
TSSOPâ20* 75 Units/Tube
NCP5425DBG TSSOPâ20* 75 Units/Tube
NCP5425DBR2 TSSOPâ20* 2500/Tape & Reel
NCP5425DBR2G TSSOPâ20* 2500/Tape & Reel
â For information on tape and reel specifications,
including part orientation and tape sizes, please
refer to our Tape and Reel Packaging Specification
Brochure, BRD8011/D.
*This package is inherently PbâFree.
© Semiconductor Components Industries, LLC, 2006
1
July, 2006 â Rev. 9
Publication Order Number:
NCP5425/D
|
▷ |