NCP330 Datasheet, PDF (1/9 Pages) ON Semiconductor – Soft-Start Controlled Load Switch

NCP330
Soft-Start Controlled Load
Switch
The NCP330 is a low Ron N−channel MOSFET controlled by a
soft−start sequence of 2 ms for mobile applications.
The very low R_DS(on) allows system supplying or battery charging
up to DC 3A.The device is enable automatically if a Power Supply is
connected on Vin pin (active High) and maintained off if no Vin
(internal pull down).
Due to a current consumption optimization, leakage current is
drastically decreased from the battery connected to the device,
allowing long battery life.
Features
• 1.8 V − 5.5 V Operating Range
• 30 mW N−MOSFET
• DC Current Up to 3 A
• Peak Current Up to 5 A
• Built−in Soft−Start 2 ms
• Reverse Voltage Protection
• Active High with Integrated Bridge
• Compliance to IEC61000−4−2 (Level 4)
8.0 kV (Contact)
15 kV (Air)
• ESD Ratings: Machine Model = B
Human Body Model = 3
• mDFN4 1.2 x 1.6 mm
• NCV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
• This is a Pb−Free Device
Typical Applications
• Mobile Phones
• Tablets
• Digital Cameras
• GPS
• Computers
Vbat
IN
OUT
1 mF
NCP330
1 mF
EN _GND
EN
www.onsemi.com
1
UDFN4
CASE 517CE
MARKING
DIAGRAM
3A M
3A = Specific Device Code
M = Date Code
PINOUT DIAGRAM
IN
GND
PAD1
OUT
EN
(Top View)
ORDERING INFORMATION
See detailed ordering and shipping information on page 8 of
this data sheet.
VBUS
USB D+
4
Port _D−
GND
IN ^CMIC OUT
Supply HS
Monitoring USB
I@C ^Signal
Routing
Accessory
Detection and ID
SBC Charger
SYSTEM
Figure 1. Typical Application Circuit
© Semiconductor Components Industries, LLC, 2015
1
April, 2015 − Rev. 2
Publication Order Number:
NCP330/D