|
NCP1201_06 Datasheet, PDF (1/19 Pages) ON Semiconductor – PWM Current−Mode Controller for Universal Off−Line Supplies Featuring Low Standby Power with Fault Protection Modes | |||
|
NCP1201
PWM CurrentâMode
Controller for Universal
OffâLine Supplies Featuring
Low Standby Power with
Fault Protection Modes
Housed in SOICâ8 or PDIPâ8 package, the NCP1201 enhances the
previous NCP1200 series by offering a reduced optocoupler current with
additional Brownout Detection Protection (BOK). Similarly, the circuit
allows the implementation of complete offâline ACâDC adapters, battery
chargers or Switchmode Power Supplies (SMPS) where standby power is
a key parameter.
The NCP1201 features efficient protection circuitry. When in the
presence of a fault (e.g. failed optocoupler, overcurrent condition, etc.)
the control permanently disables the output pulses to avoid subsequent
damage to the system. The IC only restarts when the user cycles the
mains power supply.
With the low power internal structure, operating at a fixed
60 or 100 kHz, the controller supplies itself from the highâvoltage rail,
avoiding the need of an auxiliary winding. This feature naturally eases
the designerâs task in battery charger applications. Finally, currentâmode
control provides an excellent audioâsusceptibility and inherent
pulseâbyâpulse control.
When the load current falls down to a preâdefined setpoint (VSKIP)
value, e.g. the output power demand diminishes, the IC automatically
enters the skip cycle mode and can provide excellent efficiency under
light load conditions. The skip mode is designed to operate at relatively
lower peak current so that acoustic noise that commonly takes place will
not happen with NCP1201.
Features
⢠AC Line Brownout Detect Protection, BOK Function
⢠Latchoff Mode Fault Protection
⢠No Auxiliary Winding Operation
⢠Internal Output ShortâCircuit Protection
⢠Extremely Low NoâLoad Standby Power
⢠CurrentâMode with SkipâCycle Capability
⢠Internal Overtemperature Shutdown
⢠Internal Leading Edge Blanking
⢠250 mA Gate Peak Current Driving Capability
⢠Internally Fixed Switching Frequency at 60 or 100 kHz
⢠Builtâin Frequency Jittering for EMI Reduction
⢠Direct Optocoupler Connection
⢠PbâFree Packages are Available
Typical Applications
⢠ACâDC Adapters
⢠Offline Battery Chargers
⢠Auxiliary Power Supplies (USB, Appliances, TVs, etc.)
© Semiconductor Components Industries, LLC, 2006
1
February, 2006 â Rev. 4
http://onsemi.com
MARKING
DIAGRAMS
8
1
SOICâ8
D SUFFIX
CASE 751
8
201Dx
ALYW
G
1
8
1
8
PDIPâ8
P SUFFIX
CASE 626
1201Py0
AWL
YYWWG
1
x
= Device Code: 6 for 60 kHz
y
1 for 100 kHz
y
= Device Code: 6 for 60 kHz
xx
10 for 100 kHz
A
= Assembly Location
L
= Wafer Lot
Y, YY = Year
W, WW = Work Week
G or G = PbâFree Package
PIN CONNECTIONS
BOK 1
FB 2
CS 3
GND 4
8 HV
7 NC
6 VCC
5 DRV
(Top View)
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 17 of this data sheet.
Publication Order Number:
NCP1201/D
|
▷ |