MT9M001C12STM Datasheet, PDF (1/29 Pages) ON Semiconductor – Megapixel CMOS Digital Image Sensor

MT9M001: 1/2-Inch Megapixel Digital Image Sensor
Features
1/2-Inch Megapixel CMOS Digital Image Sensor
MT9M001C12STM (Monochrome) Datasheet, Rev. M
For the latest datasheet, please visit www.onsemi.com
Features
• Array Format (5:4): 1,280H x 1,024V (1,310,720 active
pixels). Total (incl. dark pixels): 1,312H x 1,048V
(1,374,976 pixels)
• Frame Rate: 30 fps progressive scan; programmable
• Shutter: Electronic Rolling Shutter (ERS)
• Window Size: SXGA; programmable to any smaller
format (VGA, QVGA, CIF, QCIF, etc.)
• Programmable Controls: Gain, frame rate, frame size
Applications
• Digital still cameras
• Digital video cameras
• PC cameras
General Description
The ON Semiconductor MT9M001 is an SXGA-format
with a 1/2-inch CMOS active-pixel digital image sen-
sor. The active imaging pixel array of 1,280H x 1,024V. It
incorporates sophisticated camera functions on-chip
such as windowing, column and row skip mode, and
snapshot mode. It is programmable through a simple
two-wire serial interface.
This megapixel CMOS image sensor features ON Semi-
conductor’s breakthrough low-noise CMOS imaging
technology that achieves CCD image quality (based on
signal-to-noise ratio and low-light sensitivity) while
maintaining the inherent size, cost, and integration
advantages of CMOS.
Table 1:
Key Performance Parameters
Parameter
Value
Optical format
1/2-inch (5:4)
Active imager size
6.66 mm (H) x 5.32 mm (V)
Active pixels
1,280 H x 1,024 V
Pixel size
5.2 m x 5.2 m
Shutter type
Electronic rolling shutter (ERS)
Maximum data rate/
master clock
48 MPS/48 MHz
Frame
rate
SXGA
(1280 x 1024)
30 fps progressive scan;
programmable
ADC resolution
10-bit, on-chip
Responsivity
2.1 V/lux-sec
Dynamic range
68.2 dB
SNR_MAX
Supply voltage
45 dB
3.0 V3.6 V, 3.3 V nominal
Power consumption
363 mW at 3.3 V (operating);
294 W (standby)
Operating temperature
0°C to +70°C
Packaging
48-pin CLCC
The sensor can be operated in its default mode or pro-
grammed by the user for frame size, exposure, gain set-
ting, and other parameters. The default mode outputs
an SXGA-size image at 30 frames per second (fps). An
on-chip analog-to-digital converter (ADC) provides 10
bits per pixel. FRAME_VALID and LINE_VALID signals
are output on dedicated pins, along with a pixel clock
that is synchronous with valid data.
MT9M001_DS Rev. M Pub. 5/15 EN
1
©Semiconductor Components Industries, LLC ,