MC14093B_06 Datasheet, PDF (1/9 Pages) ON Semiconductor – Quad 2−Input NAND Schmitt Trigger

MC14093B
Quad 2−Input NAND"
Schmitt Trigger
The MC14093B Schmitt trigger is constructed with MOS
P−channel and N−channel enhancement mode devices in a single
monolithic structure. These devices find primary use where low power
dissipation and/or high noise immunity is desired. The MC14093B
may be used in place of the MC14011B quad 2−input NAND gate for
enhanced noise immunity or to “square up” slowly changing
waveforms.
Features
• Supply Voltage Range = 3.0 Vdc to 18 Vdc
• Capable of Driving Two Low−Power TTL Loads or One Low−Power
Schottky TTL Load Over the Rated Temperature Range
• Triple Diode Protection on All Inputs
• Pin−for−Pin Compatible with CD4093
• Can be Used to Replace MC14011B
• Independent Schmitt−Trigger at each Input
• Pb−Free Packages are Available
MAXIMUM RATINGS (Voltages Referenced to V_SS)
Symbol
Parameter
Value
Unit
V_DD
V_in, V_out
DC Supply Voltage Range
Input or Output Voltage Range
(DC or Transient)
−0.5 to +18.0
V
−0.5 to V_DD + 0.5
V
I_in, I_out Input or Output Current
(DC or Transient) per Pin
± 10
mA
P_D Power Dissipation,
per Package (Note 1)
500
mW
T_A
Ambient Temperature Range
T_stg Storage Temperature Range
T_L
Lead Temperature
(8−Second Soldering)
−55 to +125
°C
−65 to +150
°C
260
°C
Stresses exceeding Maximum Ratings may damage the device. Maximum
Ratings are stress ratings only. Functional operation above the Recommended
Operating Conditions is not implied. Extended exposure to stresses above the
Recommended Operating Conditions may affect device reliability.
1. Temperature Derating:
Plastic “P and D/DW” Packages: – 7.0 mW/_C From 65_C To 125_C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high−impedance circuit. For proper operation, V_in and V_out should be constrained
to the range V_SS v (V_in or V_out) v V_DD.
Unused inputs must always be tied to an appropriate logic voltage level (e.g.,
either V_SS or V_DD). Unused outputs must be left open.
http://onsemi.com
PDIP−14
P SUFFIX
CASE 646
MARKING
DIAGRAMS
14
MC14093BCP
AWLYYWWG
1
SOIC−14
D SUFFIX
CASE 751A
14
14093BG
AWLYWW
1
TSSOP−14
DT SUFFIX
CASE 948G
14
14
093B
ALYW G
G
1
SOEIAJ−14
F SUFFIX
CASE 965
14
MC14093B
ALYWG
1
A
WL, L
YY, Y
WW, W
G or G
= Assembly Location
= Wafer Lot
= Year
= Work Week
= Pb−Free Package
(Note: Microdot may be in either location)
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 2 of this data sheet.
© Semiconductor Components Industries, LLC, 2006
1
October, 2006 − Rev. 7
Publication Order Number:
MC14093B/D