MC14040BDTR2G Datasheet, PDF (1/9 Pages) ON Semiconductor – 12-Bit Binary Counter

MC14040B
12-Bit Binary Counter
The MC14040B 12−stage binary counter is constructed with MOS
P−Channel and N−Channel enhancement mode devices in a single
monolithic structure. This part is designed with an input wave shaping
circuit and 12 stages of ripple−carry binary counter. The device
advances the count on the negative−going edge of the clock pulse.
Applications include time delay circuits, counter controls, and
frequency−driving circuits.
Features
• Fully Static Operation
• Diode Protection on All Inputs
• Supply Voltage Range = 3.0 Vdc to 18 Vdc
• Capable of Driving Two Low−power TTL Loads or One
Low−power Schottky TTL Load Over the Rated Temperature
Range
• Common Reset Line
• Pin−for−Pin Replacement for CD4040B
• These Devices are Pb−Free and are RoHS Compliant
• NLV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
MAXIMUM RATINGS (Voltages Referenced to V_SS)
Symbol
Parameter
Value
Unit
V_DD
V_in, V_out
DC Supply Voltage Range
Input or Output Voltage Range
(DC or Transient)
−0.5 to +18.0
V
−0.5 to V_DD + 0.5
V
I_in, I_out
Input or Output Current
(DC or Transient) per Pin
± 10
mA
P_D
Power Dissipation, per Package
(Note 1)
500
mW
T_A
Ambient Temperature Range
T_stg
Storage Temperature Range
T_L
Lead Temperature
(8−Second Soldering)
−55 to +125
°C
−65 to +150
°C
260
°C
Stresses exceeding Maximum Ratings may damage the device. Maximum
Ratings are stress ratings only. Functional operation above the Recommended
Operating Conditions is not implied. Extended exposure to stresses above the
Recommended Operating Conditions may affect device reliability.
1. Temperature Derating:
Plastic “P and D/DW” Packages: – 7.0 mW/_C From 65_C To 125_C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high−impedance circuit. For proper operation, V_in and V_out should be constrained
to the range V_SS v (V_in or V_out) v V_DD.
Unused inputs must always be tied to an appropriate logic voltage level
(e.g., either V_SS or V_DD). Unused outputs must be left open.
http://onsemi.com
MARKING
DIAGRAMS
PDIP−16 ¹⁶
P SUFFIX
CASE 648
1
MC14040BCP
AWLYYWWG
SOIC−16
D SUFFIX
CASE 751B
16
14040BG
AWLYWW
1
TSSOP−16
DT SUFFIX
CASE 948F
16
14
040B
ALYW G
G
1
SOEIAJ−16
F SUFFIX
CASE 966
16
MC14040B
ALYWG
1
A
WL, L
YY, Y
WW, W
G or G
= Assembly Location
= Wafer Lot
= Year
= Work Week
= Pb−Free Package
(Note: Microdot may be in either location)
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 2 of this data sheet.
© Semiconductor Components Industries, LLC, 2013
1
April, 2013 − Rev. 10
Publication Order Number:
MC14040B/D