MC14001UB_14 Datasheet, PDF (1/6 Pages) ON Semiconductor – UB-Suffix Series CMOS Gates

MC14001UB, MC14011UB
UB-Suffix Series
CMOS Gates
The UB Series logic gates are constructed with P and N channel
enhancement mode devices in a single monolithic structure
(Complementary MOS). Their primary use is where low power
dissipation and/or high noise immunity is desired. The UB set of
CMOS gates are inverting non−buffered functions.
Features
• Supply Voltage Range = 3.0 Vdc to 18 Vdc
• Linear and Oscillator Applications
• Capable of Driving Two Low−Power TTL Loads or One
Low−Power Schottky TTL Load Over the Rated Temperature Range
• Double Diode Protection on All Inputs
• Pin−for−Pin Replacements for Corresponding CD4000 Series UB
Suffix Devices
• NLV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
• This Device is Pb−Free and is RoHS Compliant
MAXIMUM RATINGS (Voltages Referenced to V_SS)
Symbol
Parameter
Value
Unit
V_DD
V_in, V_out
DC Supply Voltage Range
Input or Output Voltage Range
(DC or Transient)
−0.5 to +18.0
V
−0.5 to V_DD + 0.5
V
I_in, I_out
Input or Output Current
(DC or Transient) per Pin
± 10
mA
P_D
Power Dissipation, per Package
(Note 1)
500
mW
T_A
Ambient Temperature Range
−55 to +125
°C
T_stg
Storage Temperature Range
−65 to +150
°C
T_L
Lead Temperature
(8−Second Soldering)
260
°C
Stresses exceeding those listed in the Maximum Ratings table may damage the
device. If any of these limits are exceeded, device functionality should not be
assumed, damage may occur and reliability may be affected.
1. Temperature Derating: “D/DW” Package: –7.0 mW/_C From 65_C To 125_C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high−impedance circuit. For proper operation, V_in and V_out should be constrained
to the range V_SS ≤ (V_in or V_out) ≤ V_DD.
Unused inputs must always be tied to an appropriate logic voltage level
(e.g., either V_SS or V_DD). Unused outputs must be left open.
http://onsemi.com
SOIC−14
D SUFFIX
CASE 751A
MARKING DIAGRAM
14
140xxUG
AWLYWW
1
xx
A
WL, L
YY, Y
WW, W
G
= Specific Device Code
= Assembly Location
= Wafer Lot
= Year
= Work Week
= Pb−Free Package
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 4 of this data sheet.
© Semiconductor Components Industries, LLC, 2014
1
July, 2014 − Rev. 10
Publication Order Number:
MC14001UB/D