MC100EP809_15 Datasheet, PDF (1/10 Pages) ON Semiconductor – Differentia HSTL/PECL/LVDS to HSTL Clock Driver

MC100EP809
3.3V 2:1:9 Differential
HSTL/PECL/LVDS to HSTL
Clock Driver with LVTTL
Clock Select and Enable
Description
The MC100EP809 is a low skew 2:1:9 differential clock driver,
designed with clock distribution in mind, accepting two clock sources
into an input multiplexer. The part is designed for use in low voltage
applications which require a large number of outputs to drive precisely
aligned low skew signals to their destination. The two clock inputs are
one differential HSTL and one differential LVPECL. Both input pairs
can accept LVDS levels. They are selected by the CLK_SEL pin
which is LVTTL. To avoid generation of a runt clock pulse when the
device is enabled/disabled, the Output Enable (OE), which is LVTTL,
is synchronous ensuring the outputs will only be enabled/disabled
when they are already in LOW state (Figure 9).
The MC100EP809 guarantees low output−to−output skew. The
optimal design, layout, and processing minimize skew within a device
and from lot to lot. The MC100EP809 output structure uses open
emitter architecture and will be terminated with 50 W to ground
instead of a standard HSTL configuration (Figure 7). To ensure the
tight skew specification is realized, both sides of the differential output
need to be terminated identically into 50 W even if only one output is
being used. If an output pair is unused, both outputs may be left open
(unterminated) without affecting skew.
Designers can take advantage of the EP809’s performance to
distribute low skew clocks across the backplane of the board. Both
clock inputs may be single−end driven by biasing the non−driven pin
in an input pair (Figure 8).
Features
• 100 ps Typical Device−to−Device Skew
• 15 ps Typical within Device Skew
• HSTL Compatible Outputs Drive 50 W to GND with no
Offset Voltage
• Maximum Frequency > 750 MHz
• 850 ps Typical Propagation Delay
• Fully Compatible with Micrel SY89809L
• PECL and HSTL Mode Operating Range: V_CCI = 3 V to 3.6 V
with GND = 0 V, V_CCO = 1.6 V to 2.0 V
• Open Input Default State
• These Devices are Pb−Free and are RoHS Compliant
www.onsemi.com
MARKING
DIAGRAMS*
32−LEAD LQFP
FA SUFFIX
CASE 873A
MC100
EP809
AWLYYWWG
32
1
1 32
QFN32
MN SUFFIX
CASE 488AM
1
MC100
EP809
AWLYYWWG
G
A
= Assembly Location
WL = Wafer Lot
YY
= Year
WW = Work Week
G or G = Pb−Free Package
(Note: Microdot may be in either location)
*For additional marking information, refer to
Application Note AND8002/D.
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 8 of this data sheet.
© Semiconductor Components Industries, LLC, 2015
1
April, 2015 − Rev. 10
Publication Order Number:
MC100EP809/D