E3ZM-V Datasheet, PDF (7/12 Pages) Omron Electronics LLC – Print mark detection photoelectric sensor in compact stainless steel housing

Nomenclature
Teaching Models
Stability indicator
(green)
Teaching indicator
(red)
Operation indicator
(yellow)
Teaching button
Safety Precautions
Refer to Warranty and Limitations of Liability on page 12.
WARNING
Low-temperature Environments
Do not touch the metal surface with your bare hands when the
This product is not designed or rated for directly or
indirectly ensuring safety of persons. Do not use it
for such a purpose.
temperature is low. Touching the surface may result in a cold
burn.
Oily Environments
Do not use the Sensor in oily environments. They may dam-
age parts and reduce the degree of protection.
CAUTION
Do not use the product with voltage in excess of
the rated voltage. Excess voltage may result in
malfunction or fire.
Never use the product with an AC power supply.
Otherwise, explosion may result.
When cleaning the product, do not apply a high-
pressure spray of water to one part of the product.
Otherwise, parts may become damaged and the
degree of protection may be degraded.
Modifications
Do not attempt to disassemble, repair, or modify the Sensor.
Outdoor Use
Do not use the Sensor in locations subject to direct sunlight.
Cleaing
Do not use thinner, alcohol, or other organic solvents.
Otherwise, the optical properties and degree of protection
may be degraded.
Cleaning
Do not use highly concentrated cleaning agents. Otherwise,
malfunction may result. Also, do not use high-pressure water
with a level of pressure that exceeds the stipulated level.
Otherwise, the degree of protection may be reduced.
Precautions for Safe Use
The following precautions must be observed to ensure safe
operation of the Sensor.
Operating Environment
Do not use the Sensor in an environment where explosive or
flammable gas is present.
Connecting Connectors
Be sure to hold the connector cover when inserting or remov-
ing the connector.
Surface Temperature
Burn injury may occur. The Sensor surface temperature rises
depending on application conditions, such as the ambient
temperature and the power supply voltage. Use caution when
operating or performing maintenance on the Sensor.
Cable Bending
Do not bend the cable in temperatures of −25° C or below. Oth-
erwise, the cable may be damaged.
When using an XS3F Connector, be sure to tighten the con-
nector lock by hand; do not use pliers or other tools.
If the tightening is insufficient, the degree of protection will
not be maintained and the Sensor may become loose due to
vibration. The appropriate tightening torque is 0.3 to 0.4 N·m.
When using another, commercially available connector,
follow the usage and tightening torque instructions provided
by the manufacturer.
Load
Do not use a load that exceeds the rated load.
E3ZM-V
7