XN2_1011 Datasheet, PDF (5/6 Pages) Omron Electronics LLC – Easy-wire connectors for Industrial Components

Safety Precautions
■ General Precautions
• Do not pull on the Connectors or cables. Doing so may cause dam-
age to the Connectors or cause the cables to disconnect.
• Install the Connectors in a location where they will not be stepped
on, to prevent disconnection of the cables or damage to the Con-
nectors. If the Connectors have to be installed in such a location,
use a protective cover.
• Make sure that the Connectors are mated in the correct direction.
Mating the Connectors incorrectly will damage to the Connectors.
• Do not use the Connectors if the lock lever is bent or broken. Doing
so may cause the Connector to become loose or the device to mal-
function.
• Before mounting Connectors to a PCB, make sure that the Connec-
tors are positioned in the correct direction.
• Before bending a cable to connect it to a Connector, check the
bending specifications of the cable to be used.
• Do not exceed the rated current of the cable. Always check the
rated current of each cable to be used.
• Do not use pliers or other tools to remove the Connectors.
• Hold the Connectors firmly by hand when handling them. Do not
use excessive force to push the Connectors. Forcing the Connec-
tors may result in injury.
• These Connectors do not resist water. Do not use Connectors in
places where water or oil may be sprayed onto the Connectors.
■ Precautions for Correct Use
Wiring
• Insert one wire into each insertion hole. Inserting two or more wires
into a single hole may cause unexpected problems.
• Make sure that no power is being supplied to a Connector before
wiring, inserting, or removing the Connector. Doing so may result in
electric shock.
• Follow the wiring diagrams for the device being used when wiring
the cables.
• Strip the cables according to the instructions in the applicable oper-
ation manual, making sure not to damage the wires.
• Do not use a screwdriver with a tip larger than the specified width
when wiring the Connectors.
• Make sure short-circuits are not created, e.g., by protruding wires.
Inserting and Removing Connectors
• When connecting or disconnecting Connectors, always hold the
case of the Connector.
• When mating Connectors, insert the Connector fully into the back
of the socket, and then make sure that the Connector will not
become loose by lightly pulling it in the opposite direction.
Recommended Screwdriver
• Use a flat-blade screwdriver with a tip of 2 mm max. Do not use
screwdrivers that gradually widen towards the base of the screw-
driver.
• Using other screwdrivers may cause damage to the adjacent poles.
Easy-wire connectors for Industrial Components XN2 185