CS1W-EIP21 Datasheet, PDF (5/8 Pages) Omron Electronics LLC – SYSMAC CS-series EtherNet/IP Unit

CS1W-EIP21
Network Configurator Requirements
The Network Configurator Ver. 3.0 or higher is a software package designed for building, setting, and controlling a multi-vendor EtherNet/IP
Network using OMRON's EtherNet/IP. It is included in CX-One version 3.0. The Network Configurator provides the following functions for building,
setting, and controlling EtherNet/IP.
Item
Operating environment
Network
connection
method
Serial interface
Ethernet interface
Location on Network
Number of Units that can be connected to
Network
Network control functions
Main functions
Configuration functions
Supported file formats
Specification
Refer to the CX-One Setup Manual (Cat. No. W463).
CXONE-AL@@C-V@/CXONE-AL@@D-V@
CS1/CJ1
CJ2
CPU Unit’s Peripheral or RS-232C port
CPU Unit’s USB or RS-232C port
EtherNet/IP Unit’s Ethernet port
CPU Unit’s Ethernet port
EtherNet/IP Unit’s Ethernet port
A single node address is used (only when directly connected to EtherNet/IP).
A single Network Configurator per Network (More than one Configurator cannot be used in the same system.)
• The Network configuration can be created and edited regardless of whether the Network Configurator is online or
offline.
• The Network configuration can be read from a file or the network.
The EDS files used by the Network Configurator can be installed and deleted.
Configurator network configuration files (*.ncf)
Configuration files (*.ncf) created using the Network Configurator for EtherNet/IP (version 2) can be imported by
selecting External Data - Import from the File Menu.
External Interface
CS1W-EIP21
LED Indicators
These indicators display the Unit and network status.
Unit number setting switch
This rotary switch sets the unit number on the CPU Unit with one hexadecimal digit.
Node address setting switches
These two rotary switches set the node address for the EtherNet/IP Unit on the
EtherNet/IP network with two hexadecimal digits.
This setting is also used as the host ID in the default IP address (192.168.250.@).
Label showing IP address
A label that can be used to show the IP address and subnet mask is provided.
Ethernet connector
The network is connected with shielded twisted-pair cable.
Ethernet Connectors
The following standards and specifications apply to the connectors for the Ethernet twisted-pair cable.
• Electrical specifications: Conforming to IEEE802.3 standards.
• Connector structure: RJ45 8-pin Modular Connector
(conforming to ISO 8877)
Connector pin
1
2
3
4
5
6
7
8
Hood
Signal name
Transmission data +
Transmission data −
Reception data +
Not used.
Not used.
Reception data −
Not used.
Not used.
Frame ground
Abbr.
TD+
TD−
RD+
−
−
RD−
−
−
FG
Signal direction
Output
Output
Input
−
−
Input
−
−
−
5