D2MQ Datasheet, PDF (4/4 Pages) Omron Electronics LLC – Subminiature Basic Switch

D2MQ
Precautions
s MOUNTING
Mount firmly using M1.4 screws and 1 kg-cm tightening torque.
Mounting hole matching dimensions
When mounting onto a metal body, always install a separator
between the switch and the mounting panel.
Design the insulation separator (made up of hard material) into
the shape shown below.
Separator shape
D2MQ
s SOLDERING
Holding the switch at the free position, solder the lead wire to
its terminal within 3 seconds, using a soldering iron rated at
less than 15 W with a tip temperature of less than 280°C.
Excess wattage or prolonged heating can deteriorate the
electrical characteristics of the switch.
s OPERATION
Set the operating force of the pushbutton and leaf lever at less
than twice the OF standard value.
Always make the OT value larger than the specification value.
Do not change the operating position of the actuator.
Do not operate at extremely slow speed; also do not use the
switch with its pushbutton located between the free position
and the operating position.
Mount the pin pushbutton type in such a way that the stroke of
the pushbutton and the stroke of the operating control overlap
on a vertical line.
Do not operate the switch roughly as it may deteriorate the
functions of the switch.
Do not apply excessive force to the actuator of the leaf lever
type along its operating direction, opposite to its operating
direction, or in the lateral direction.
Omron Europe B.V. EMA-ISD, tel:[phone], fax:[phone], http://www.eu.omron.com/ema
Cat. No. GC SW5
4
4/98
Specifications subject to change without notice.
Printed in the U.S.A.