E2C-JC4CH Datasheet, PDF (17/23 Pages) Omron Electronics LLC – Separate Amplifier Sensor with Sensitivity Adjustment

E2C/E2C-H
E2C-A@4A
Using P2CF-11, P2CF-08
When aligning the Amplifier Unit vertically with the Socket, consider
the space required for the hooks and allow a leeway of about 20 mm
above and below the Amplifier Unit.
Removing the Amplifier Unit
• When the Amplifier Unit is mounted using the Y92F-30, loosen the
screws on the adapter, spread the hooks at the top and bottom, and
remove the Adapter.
Hook
Duct or
other object
P2CF-11
Panel _P2CF-08
20
Mounting Embedded in a Panel
(1)When using the Y92F-30 Embedded Mounting Adapter, insert the
Amplifier Unit into a square hold in the panel, attach the Adapter
from the back and press in to reduce the gap with the panel. Then
secure the Adapter with the screws.
• Using Y92F-70, Y92F-71
Press in on the hooks with your thumb and forefinger and press
forward on the Amplifier Unit.
Panel
Y92F-30
(2)When using the Y92F-70 or Y92F-71 Embedded Mounting
Adapter, just press the Amplifier into a square hole in the panel. If
the panel coating is too thick and the hooks do not lock in place,
spread the hooks from the back by pushing in the directions of the
arrows.
Insert the Amplifier Unit and
then spread the hooks. _Panel
Hook
Insert the Sensor and then
spread the hooks.
● Wiring
Self-diagnostic Output
When not using the self-diagnostic output, connect the orange wire to
0 V or cut it and wrap it with insulation tape so that it does not come
into contact with other terminals.
● Miscellaneous
The sensor does not have a water-resistant structure. Do not use it
where it would be subjected to water or water vapor.
17