English
Language : 

E2C-CR8B Datasheet, PDF (16/24 Pages) Omron Electronics LLC – Separate Amplifier Sensor with Sensitivity Adjustment
E2C/E2C-H
● Mounting
Mounting the Amplifier Unit
E2C-JC4A
Lengthwise Mounting
(1)Secure the Mounting Bracket with the enclosed M3 screws.
(2)Loosen the M2.6 cover screw and remove the cover.
(3)Slide the protrusion on the Amplifier Unit into the hole on the
Mounting Bracket.
(4)Using the M3 mounting screw inside the Amplifier Unit, secure the
Amplifier Unit to the mounting base.
(5)Secure the cover to the case.
M2.6 cover screw
5
2
M3 Mounting
screw
4
Mounting
Bracket
Mounting
base
3
1 M3 screw (enclose)
M3
Mounting to the Side
(1)Loosen the M2.6 cover screw and remove the cover. Loosen the
M2.6 cover screw and remove the cover, and remove the M3
screw.
(2)Attached the enclosed M3 screw to the cover and secure the cover
to the case.
(3)Secure the Amplifier Unit with M3 screws from the side. You must
provide these screws.
1 M2.6 cover screw
M3 Mounting screw
M3 screw
(enclose)
2
Mounting base
3
M3
M3 screws
After completing adjustments, attach the
enclosed caution label over the adjustment
holes to prevent adjustment mistakes.
ON'T TOU
E2C-A@4A
Using P2CF-11, P2CF-08
When aligning the Amplifier Unit vertically with the Socket, consider
the space required for the hooks and allow a leeway of about 20 mm
above and below the Amplifier Unit.
Hook
Duct or
other object
P2CF-11
Panel P2CF-08
20
Mounting Embedded in a Panel
(1)When using the Y92F-30 Embedded Mounting Adapter, insert the
Amplifier Unit into a square hold in the panel, attach the Adapter
from the back and press in to reduce the gap with the panel. Then
secure the Adapter with the screws.
Panel
Y92F-30
(2)When using the Y92F-70 or Y92F-71 Embedded Mounting
Adapter, just press the Amplifier into a square hole in the panel. If
the panel coating is too thick and the hooks do not lock in place,
spread the hooks from the back by pushing in the directions of the
arrows.
Insert the Amplifier Unit and
then spread the hooks. Panel
Hook
Insert the Sensor and then
spread the hooks.
16