G2RV Datasheet, PDF (10/12 Pages) Omron Electronics LLC – Slim Relay

Precautions
■ Precautions for Connection
• Do not move the screwdriver up, down, or from side to side while it is inserted in the hole. Doing so may cause damage to internal components
(e.g., deformation of the clamp spring or cracks in the housing) or cause deterioration of insulation.
• Do not insert the screwdriver at an angle. Doing so may break the side of socket and result in a short-circuit.
• Do not insert two or more wires in the hole. Wires may come in contact with the spring causing a temperature rise or be subject to sparks.
(There are two wiring holes for each terminal.)
• Insert the screwdriver along the hole wall as shown below.
• If lubricating liquid, such as oil, is present on the tip of screwdriver, the screwdriver may fall out resulting in injury to the operator.
• Insert the screwdriver into the bottom of the hole. It may not be possible to connect cables properly if the screwdriver is inserted incorrectly.
■ General Precautions
• Do not use the product if it has been dropped on the ground. Dropping the product may adversely affect performance.
• Confirm that the socket is securely attached to the mounting track before wiring. If the socket is mounted insecurely it may fall and injure the
operator.
• Insure that the socket is not charged during wiring and maintenance. Not doing so may result in electric shock.
• Do not pour water or cleansing agents on the product. Doing so may result in electric shock.
• Do not use the socket in locations subject to solvents or alkaline chemicals.
• Do not use the socket in locations subject to ultraviolet light (e.g., direct sunlight). Doing so may result in markings fading, rust, corrosion, or
resin deterioration.
• Do not dispose of the product in fire.
■ Removing from Mounting Rail
To remove the socket from the mounting rail, insert the tip of screwdriver in the fixture rail, and move it in the direction shown below.
■ Wiring Procedure for G2RV-SL500 series
Wire removal
Wire insertion
Screwdriver hole
Wire connection hole
Insert the specified screwdriver into the release hole.
Wire
Insert the exposed conductor into the connection hole.
Removing wire.
No other tools are required.
Note: In case of wiring stranded wires without ferrules screwdriver
should be inserted before inserting the wire. Screwdriver
should be removed after fully insertion of the wire.
Removing screwdriver.
244
Slim Relay G2RV