Z4D-B01 Datasheet, PDF (1/6 Pages) Omron Electronics LLC – Micro-displacement Sensor

Micro-displacement Sensor
Z4D-B01
I Dimensions
Note: All units are in millimeters unless otherwise indicated.
2-175489-4
(Tyco Electronics AMP)
I Features
• Easier control enabled by built-in processor circuit.
• Resolution: ±10 µm.
• Operating area: 6.5±1 mm.
• Adapts well to changes in reflection factor using division processing.
Mounting reference plane
Emitter axis
Center of
Detector
Mounting Hole Dimensions
Two, 2.3^+-00.1 dia.
Two,
2
+0.05
−0.15
dia.
Two, 1 dia.
Two, 3.5 dia.
Recommended Mating Connectors:
Tyco Electronics AMP
175778-4 (crimp connector)
173977-4 (press-fit connector)
Pin no. Remarks
1
PLS
2
VCC
3
OUT
4
GND
Unless otherwise specified, the
tolerances are as shown below.
Dimensions
3 mm max.
3 < mm ≤ 6
6 < mm ≤10
10 < mm ≤ 18
18 < mm ≤ 30
30 < mm ≤ 50
Tolerance
±0.3
±0.375
±0.45
±0.55
±0.65
±0.8
I Ordering Information
Description
Micro-displacement sensor
Model
Z4D-B01
I Absolute Maximum Ratings (Ta = 25°C)
Item
Supply voltage
LED pulse light emission control signal
LED light emission pulse
Operating temperature
Storage temperature
Symbol
V_CC
PLS
t_FP
T_opr
T_stg
Value
7
7
100
–10 to 65
–25 to 80
Unit
VDC
VDC
ms
°C
°C
Remarks
---
LED
---
No icing or condensation
---
I Electrical and Optical Characteristics (Ta = –10°C to 65°C)
Item
Supply voltage
Output voltage
Response time
LED pulse light emission
control signal
V_CC
OUT
tr
PLS
Symbol
Rated value
5 VDC±10%
0.2 VDC to (V_CC–0.3) V
100 µs max.
3.5 VDC to V_CC
Remarks
Ripple (p-p): 10 mV p-p max.
(see note 1)
(see note 2)
(see note 3)
Note: 1. Load impedance (between OUT-GND) is set at more than 10 kΩ.
2. The time for output voltage to rise from 10% to 90% of the full output range.
3. Apply the voltage ranging from 3.5 V to V_CC on the LED pulse light emission control signal terminal. In this case, a maximum of 2 mA
(TYP 1 mA) current is sunk.
120
Micro-displacement Sensor Z4D-B01