XW2Z-050J-A1 Datasheet, PDF (1/12 Pages) Omron Electronics LLC – Simplify Wiring between Motor Controls and Omrons Position Control PLC Modules

Position Control Terminal Block
XW2B
Simplify Wiring between Motor Controls
and Omron’s Position Control PLC
Modules
H Relays control signals between a servo
driver and the PLC position control module
or CQM1H PLC with pulse I/O capability
H Connectors are wired with a single
screwdriver and no soldering is required
H Dedicated cables connect terminal blocks to
position control modules
H Requires 24 VDC for control signal use
H Terminal block organizes wiring and saves
space; uses M3 screws
H Mounts to DIN track or with screws for
panel mounting
NTLP: Don’t forget the standards.
Ordering Information
J POSITION CONTROL TERMINAL BLOCKS
Appearance
Applicable servo driver
U-series: R88D-UPjjj
W-series: R88D-WTjjj
Applicable position control
module/CQM1H
Pulse I/O Board
C200H-NC112
C200HW-NC113
Part number
XW2B-20J6-1B
C200H-NC211
C200HW-NC213
C200HW-NC413
XW2B-40J6-2B
CQM1H-PLB21
XW2B-20J6-3B
J CABLES
Cables Between Servo Driver and Terminal Block
Appearance
Position control
terminal block
XW2B-20J6-1B,
XW2B-40J6-2B
(See Note)
XW2B-20J6-3B
Applicable servo driver
R88D-UPjjj
R88D-WTjjjj
Cable length
1 m (3.28 ft)
2 m (6.56 ft)
1 m (3.28 ft)
2 m (6.56 ft.)
Part number
XW2Z-100J-B1
XW2Z-200J-B1
XW2Z-100J-B4
XW2Z-200J-B4
Note: Two cables will be required on the Servo Driver side if the XW2B-40J6-2B Terminal Block is used for two-axis control.
1