EE-SX493_1 Datasheet, PDF (1/4 Pages) Omron Electronics LLC – Photomicrosensor (Transmissive)

Photomicrosensor (Transmissive)
EE-SX493
I Dimensions
Note: All units are in millimeters unless otherwise indicated.
6
0.2
9.5
(1.25)
(1.25)
Cross section AA
6.5±0.05
6.9±0.5
Five, 0.25 ^{Five, 0.5}
Pull-off
taper:
1/25
max.
0.75±0.1
Cross section BB
Internal Circuit
7±0.1
Two,
1
0
−0.2
dia. (Tip
dimension)
K
V
O
Unless otherwise specified, the
A
G
tolerances are as shown below.
Terminal No.
A
K
V
O
G
Name
Anode
Cathode
Power supply
(Vcc)
Output (OUT)
Ground (GND)
Dimensions
3 mm max.
3 < mm ≤ 6
6 < mm ≤ 10
10 < mm ≤ 18
18 < mm ≤ 30
Tolerance
±0.125
±0.150
±0.180
±0.215
±0.260
I Features
• Incorporates an IC chip with a built-in detector element and amplifier.
• Incorporates a detector element with a built-in temperature com-
pensation circuit.
• A wide supply voltage range: 4.5 to 16 VDC
• Directly connects with C-MOS and TTL.
• Allows highly precise sensing with a 0.2-mm-wide sensing aperture.
• RoHS Compliant.
I Absolute Maximum Ratings (Ta = 25°C)
Item
Symbol Rated value
Emitter
Forward current
I_F
50 mA (see note 1)
Reverse voltage
V_R
4V
Detector Power supply voltage V_CC
16 V
Output voltage
V_OUT
28 V
Output current
I_OUT
16 mA
Permissible output P_OUT
dissipation
250 mW
(see note 1)
Ambient Operating
temperature _Storage
Topr –40°C to 60°C
Tstg –40°C to 85°C
Soldering temperature
Tsol 260°C (see note 2)
Note: 1. Refer to the temperature rating chart if the ambient temper-
ature exceeds 25°C.
2. Complete soldering within 10 seconds.
I Ordering Information
Description
Photomicrosensor (transmissive)
Model
EE-SX493
I Electrical and Optical Characteristics (Ta = 25°C)
Item
Symbol
Emitter
Detector
Forward voltage
V_F
Reverse current
I_R
Peak emission wavelength λ_P
Low-level output voltage V_OL
High-level output voltage V_OH
Current consumption
I_CC
Peak spectral sensitivity λ_P
wavelength
LED current when output is OFF
I_FT
LED current when output is ON
Hysteresis
∆H
Response frequency
f
Response delay time
Response delay time
t_PLH (t_PHL)
t_PHL (t_PLH)
Value
1.2 V typ., 1.5 V max.
0.01 µA typ., 10 µA max.
940 nm typ.
0.12 V typ., 0.4 V max.
15 V min.
5 mA typ., 10 mA max.
870 nm typ.
10 mA typ., 15 mA max.
15% typ.
3 kHz min.
3 µs typ.
20 µs typ.
Condition
I_F = 20 mA
V_R = 4 V
I_F = 20 mA
V_CC = 4.5 to 16 V, I_OL = 16 mA, I_F = 15 mA
V_CC = 16 V, R_L = 1 kΩ, I_F = 0 mA
V_CC = 16 V
V_CC = 4.5 to 16 V
V_CC = 4.5 to 16 V
V_CC = 4.5 to 16 V (see note 1)
V_CC = 4.5 to 16 V, I_F = 15 mA, I_OL = 16 mA (see note 2)
V_CC = 4.5 to 16 V, I_F = 15 mA, I_OL = 16 mA (see note 3)
V_CC = 4.5 to 16 V, I_F = 15 mA, I_OL = 16 mA (see note 3)
172
Photomicrosensor (Transmissive) EE-SX493