D7E Datasheet, PDF (1/4 Pages) Omron Electronics LLC – Sealed Tilt Switch

Sealed Tilt Switch
D7E
• Pure mechanical vibration detector
• Sealed enclosure
• Output capacity from 0.1 A at 5 VDC to 100 mA at 30 VDC
• RoHS Compliant
Ordering Information
Operating Angle
50 to 80 degrees
Model
D7E-3
Characteristics
Operating angle
Returning angle
Permissible mounting level
Contact form
Mounting
Soldering
Ratings
Insulation resistance
Contact resistance
Vibration during
transportation
Shock
Operating temperature and
humidity
Storage temperature and
humidity
Protection
Tilt of 50 to 80 degrees, when the switch is tilted gradually (approx. 1 degree/s) from the horizontal
Tilt of more than 25 degrees, when the switch is tilted gradually (approx. 1 degree/s) from the horizontal
1 degree max. from the horizontal
Single pole single throw (NC contact / slow action)
Pitch: 30 mm 2 screws (M3)
Height: 5.3 mm
Soldering iron: temperature 350 ±10°, 3 sec. max
5 VDC, 0.1 mA to 30 VDC, 100 mA (resistive load)
100 MΩ min. (250 VDC, between each terminal of the same polarity)
To measure off condition
300 m Ohm max. (Initial value)
Condition: Vibration: 200 gal (1 cycle: 0.5 sec.)
Vibration direction: 2 axial directions
Time: Total 50 hours
Condition: Acceleration: 980 m/s² 3 times
Shock direction: 3 axial directions
Temperature: -25° to +60° (with no icing and condensation)
Humidity: 45 to 95% RH
Temperature: -25° to +60° (with no icing and condensation)
Humidity: 45 to 95% RH protection
IP67
Sealed Tilt Switch D7E
1