EM513 Datasheet, PDF (1/2 Pages) Semikron International – Standard silicon rectifier diodes

Email: [e-mail] Website: www.olitech-elec.com
EM513 THRU EM520 GENERAL PURPOSE SILICON RECTIFIER
Reverse Voltage - 1600 to 2000 Volts Forward Current - 1.0 Ampere
DO-41
0.107 (2.7)
0.080 (2.0)
DIA.
1.0 (25.4)
MIN.
0.205 (5.2)
0.160(4.2)
0.034 (0.9)
0.028 (0.7)
DIA.
1.0 (25.4)
MIN.
Dimensions in inches and (millimeters)
FEATURES
The plastic package carries Underwriters Laboratory
Flammability Classification 94V-0
Construction utilizes void-free
molded plastic technique
Low reverse leakage
High forward surge current capability
High temperature soldering guaranteed:
250 C/10 seconds,0.375”(9.5mm) lead length,
5 lbs. (2.3kg) tension
MECHANICAL DATA
Case: JEDEC DO-41 molded plastic body
Terminals: Plated axial leads, solderable per MIL-STD-750,
Method 2026
Polarity: Color band denotes cathode end
Mounting Position: Any
Weight:0.26 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 C ambient temperature unless otherwise specified.
Single phase half-wave 60Hz,resistive or inductive load,for capacitive load current derate by 20%.
SYMBOLS
EM513
EM516
EM520
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified current
0.375”(9.5mm) lead length at TA=75 C
Peak forward surge current
8.3ms single half sine-wave superimposed on
rated load (JEDEC Method)
Maximum instantaneous forward voltage at 1.0A
Maximum DC reverse current TA=25 C
at rated DC blocking voltage TA=100 C
Typical junction capacitance (NOTE 1)
Typical thermal resistance (NOTE 2)
Operating junction and storage temperature range
VRRM
VRMS
VDC
I(AV)
IFSM
VF
IR
CJ
RqJA
TJ,TSTG
1600
1120
1600
1800
1260
1800
1.0
2000
1400
2000
30.0
1.1
5.0
50.0
15.0
50.0
-65 to +175
Note:1.Measured at 1MHz and applied reverse voltage of 4.0V D.C.
2.Thermal resistance from junction to ambient at 0.375”(9.5mm)lead length,P.C.B. mounted
OLITECH ELECTRONICS CO. LTD.
UNITS
VOLTS
VOLTS
VOLTS
Amp
Amps
Volts
uA
pF
C/W
C
Page:P2-P1