English
Language : 

MSC23V26418TD-XXBS8 Datasheet, PDF (10/10 Pages) OKI electronic componets – 2,097,152-Word x 64-Bit DYNAMIC RAM MODULE : FAST PAGE MODE TYPE
◁
Semiconductor
MSC23V26418TD
Notes: 1. A start-up delay of 200µs is required after power-up, followed by a minimum of eight initialization cycles
(/RAS only refresh or /CAS before /RAS refresh) before proper device operation is achieved.
2. The AC characteristics assume tT = 5ns.
3. VIH(Min.) and VIL(Max.) are reference levels for measuring input timing signals. Transition times (tT) are
measured between VIH and VIL.
4. This parameter is measured with a load circuit equivalent to 1 TTL load and 100pF.
The output timing reference levels are VOH = 2.0V and VOL = 0.8V.
5. Operation within the tRCD(Max.) limit ensures that tRAC(Max.) can be met.
tRCD(Max.) is specified as a reference point only. If tRCD is greater than the specified tRCD(Max.) limit, then
the access time is controlled by tCAC.
6. Operation within the tRAD(Max.) limit ensures that tRAC(Max.) can be met.
tRAD(Max.) is specified as a reference point only. If tRAD is greater than the specified tRAD(Max.) limit, then
the access time is controlled by tAA.
7. tOFF(Max.) and tOEZ(Max.) define the time at which the output achieves the open circuit condition and are
not referenced to output voltage levels.
8. tRCH or tRRH must be satisfied for a read cycle.
9. tWCS, tCWD, tRWD, tAWD and tCPWD are not restrictive operating parameters. They are included in the data
sheet as electrical characteristics only. If tWCS ≥ tWCS(Min.), then the cycle is an early write cycle and the
data out will remain open circuit (high impedance) throughout the entire cycle. If tCWD ≥ tCWD(Min.), tRWD
≥ tRWD(Min.), tAWD ≥ tAWD(Min.) and tCPWD ≥ tCPWD(Min.), then the cycle is a read modify write cycle and
data out will contain data read from the selected cell; if neither of the above sets of conditions is satisfied,
then the condition of the data out (at access time) is indeterminate.