SFP-CH20 Datasheet, PDF (1/6 Pages) OKI electronic componets – Soldering and Rework System

Soldering and Rework System
Cartridge heater technology provides soldering and rework performance to suit even the most
demanding SMT removal and placement applications. The cartridges provide fast thermal
performance and respond quickly to the load demands. A small shaft diameter provides access to
tightly cramped rework areas and enables the most difficult operations to be performed
effortlessly.
Part No.
MFR-SRC
INCLUDES
MFR-PS1K
MFR-HSR
MFR-WSSR
MFR-SRC SOLDERING & REWORK SYSTEM
Description
Soldering and Rework System
Two Port Universal Voltage Power Supply
Soldering and Rework Hand-piece
Soldering Workstand
Contents subject to change without notice
Standard Soldering Tip Cartridges
The Standard Soldering Tip Cartridges are used with the MFR-HSR Soldering & Rework Hand-piece
and have been designed to deliver outstanding performance for the majority of point-to-point
MFR-PTZ, MFR-SRC, MFR-PST, MFR-STZ
Ambient Operating Temperature:10- 40°C
Maximum Enclosure Temperature:55°C
Input Line Voltage:100- 240 VAC, grounded circuit
Input Line Frequency:50/60 Hz
Power Consumption:65 Watts max.
Output Power:
50 Watts max. at 22°C ambient temperature
Output Frequency:450 KHz
Power Cord 3-Wire:183cm (18/3") SJT
Power Supply Dimensions w x d x h:
122mm x 200mm x 152.5mm (4.8" x 8" x 6")
Agency Tested Per:IEC 61000-6-1,EC 61000-6-3 and
UL499, FCC CFR Part 15
Tip-to-Ground Potential:< 2mV
Tip-to-Ground Resistance:< 2 ohms
Idle Temperature Stability:± 1.1°C in still air
Hand-piece Cable Length:
L=71cm (48"), burn proof, ESD safe
Connector:8-pin power connector
Workstand Dimensions w x d x h:
100 mm x 200 mm x 100 mm (4" x 8" x 4")