HEF4104B_09 Datasheet, PDF (1/14 Pages) NXP Semiconductors – Quad low-to-high voltage translator with 3-state outputs

HEF4104B
Quad low-to-high voltage translator with 3-state outputs
Rev. 07 — 16 December 2009
Product data sheet
1. General description
The HEF4104B is a quad low voltage-to-high voltage translator with 3-state outputs. It
provides the capability of interfacing low voltage circuits to high voltage circuits. For
example low voltage Local Oxidation Complementary MOS (LOCMOS) and Transistor
Transistor Logic (TTL) to high voltage LOCMOS. It has four data inputs (A0 to A3), an
active HIGH output enable input (OE), four data outputs (B0 to B3) and their complements
(B0 to B3).
With OE = HIGH, the outputs B0 to B3 and B0 to B3 are in the low impedance ON-state,
either HIGH or LOW as determined by the inputs A0 to A3. With OE = LOW, the outputs
B0 to B3 and B0 to B3 are in the high-impedance OFF-state.
It uses a common negative supply (V_SS) and separate positive supplies for the inputs
(V_DD(A)) and the outputs (V_DD(B)). V_DD(A) must always be less than or equal to V_DD(B), even
during power turn-on and turn-off. For the permissible operating range of V_DD(A) and
V_DD(B) see Figure 4.
Each input protection circuit is terminated between V_DD(B) and V_SS. This allows the input
signals to be driven from any potential between V_DD(B) and V_SS, without regard to current
limiting. When driving from potentials greater than V_DD(B) or less than V_SS, the current at
each input must be limited to 10 mA.
It operates over a recommended V_DD power supply range of 3 V to 15 V referenced to V_SS
(usually ground). Unused inputs must be connected to V_DD, V_SS, or another input. It is
also suitable for use over the full industrial (−40 °C to +85 °C) temperature range.
2. Features
„ Fully static operation
„ 5 V, 10 V, and 15 V parametric ratings
„ Standardized symmetrical output characteristics
„ Inputs and outputs are protected against electrostatic effects
„ Operates across the full industrial temperature range from −40 °C to +85 °C
„ Complies with JEDEC standard JESD 13-B
3. Applications
„ Industrial