M25P05-A_08 Datasheet, PDF (38/52 Pages) Numonyx B.V – 512-Kbit, serial flash memory, 50 MHz SPI bus interface

DC and AC parameters
10 DC and AC parameters
M25P05-A
This section summarizes the operating and measurement conditions, and the DC and AC
characteristics of the device. The parameters in the DC and AC characteristic tables that
follow are derived from tests performed under the measurement conditions summarized in
the relevant tables. Designers should check that the operating conditions in their circuit
match the measurement conditions when relying on the quoted parameters.
Table 10. Operating conditions
Symbol
Parameter
Min
Max
Unit
V_CC Supply voltage
T_A
Ambient operating temperature
2.3⁽¹⁾
3.6
V
–40
85
°C
1. Only in products with process technology code Y. In products with process technology code X, V_CC(min) is
2.7 V.
Table 11. AC measurement conditions⁽¹⁾
Symbol
Parameter
Min
Max
Unit
C_L
Load capacitance
Input rise and fall times
30
pF
5
ns
Input pulse voltages
0.2V_CC to 0.8V_CC
V
Input timing reference voltages
0.3V_CC to 0.7V_CC
V
Output timing reference voltages
V_CC / 2
V
1. Output Hi-Z is defined as the point where data out is no longer driven.
Figure 21. AC measurement I/O waveform
Input levels
0.8VCC
0.2VCC
Input and output
timing reference levels
0.7VCC
0.5VCC
0.3VCC
AI07455
Table 12. Capacitance⁽¹⁾
Symbol
Parameter
Test condition
Min
C_OUT Output capacitance (Q)
V_OUT = 0 V
C_IN Input capacitance (other pins)
V_IN = 0 V
1. Sampled only, not 100% tested, at T_A = 25 °C and a frequency of 25 MHz.
Max
8
6
Unit
pF
pF
38/52